38LikesXray XT4 Thread
06-12-2019, 02:19 PM
#33
Got it give it a look see. didn't see it go though as my buddy ended up breaking a rear a-arm I think on an odd hit. It looks good though, got the standard XRay look to it. Body may take a bit growing used to here but looking forward to seeing him lay some laps down with it.
06-19-2019, 03:57 PM
#34
Got it give it a look see. didn't see it go though as my buddy ended up breaking a rear a-arm I think on an odd hit. It looks good though, got the standard XRay look to it. Body may take a bit growing used to here but looking forward to seeing him lay some laps down with it.
06-22-2019, 12:24 PM
#37
First day out for practice and tuning on carpet went really well. I swapped my slipper out of my xb4 for the gear diff, which I will try again once I get the correct fluid,(going to try 500K to start). it steers really well, jumps amazing, and has corner speed to spare. Only change from stock was the change back pills to get 1 degree antisquat, and 3 degrees toe. two felt a tad bit wishy washy in the rear, felt the same on my XT2, and inner hole on rear arm. Everything else was box, so 97% is stock, It just seems to drive better then the tekno I swapped mid pack with with a friend of mine who has the ET410 fully upgraded and tuned specifically for carpet, which makes the trucks equal in price, but his still broke during the day, and mine didn't. Overall impression is a fantastic truck. I do dislike one thing and that could be a point of contention down the road. Needing all of those washers behiond the front arms could cause a hinge pin failure. I'd like to see a redesign where its more of an xb4 inner part of the arm, and xt2 outer part without the holes and gap to run on the XT2, also some harder front arms would be nice, but the mediums didnt take much away.
06-30-2019, 06:36 AM
#40
Anyone know if you’ll be able to run short course wheels on these like you can the ET410?
07-20-2019, 07:32 PM
#44
Xray noob here, just finished building my XT4 and was wondering a few things? Is the kit set-up more of a dirt or carpet set-up? Also I'm assuming with Xrays spring ratings the more "dots" the stiffer the springs? I'll be running mine on a 1/8 scale sized loose track running Jconcepts double d's tires, what do you guys suggest I pick up for the truck? smaller swaybars, softer springs..ect? Thanks in advance!
07-20-2019, 10:42 PM
#45
Tech Regular
iTrader: (1)
Xray noob here, just finished building my XT4 and was wondering a few things? Is the kit set-up more of a dirt or carpet set-up? Also I'm assuming with Xrays spring ratings the more "dots" the stiffer the springs? I'll be running mine on a 1/8 scale sized loose track running Jconcepts double d's tires, what do you guys suggest I pick up for the truck? smaller swaybars, softer springs..ect? Thanks in advance!