odoylrulz

iTrader: (13)

funny you should ask, this just came out on buggy-sport.info today
answer to your question

odoylrulz

iTrader: (13)

fhm about the servos, I would have to say to get ace servos. They are really high quality and a reasonably priced. Also, they are made by thunder tiger.you can find them at amainhobbies.com

Cain

iTrader: (294)

What does the negative number mean on the first set of block explanations?

odoylrulz

iTrader: (13)

that is the antisquat, I guess there are two points for adjusting anitsquat

bobf24

iTrader: (28)

if you find out for sure that you can run 7.4V with spektrum and any servo be sure to post here, I've been running lipo all last year, but I ran a 6V regulator, I just assumed I needed one and never thought to try it with out,

Machine's R/C H

I use Futaba S9351 servos with very good luck so far.

I cut the rear tower with a dremel just below the rear upper wing mount screws. Then I flip the tower over and cut it so that it will fit across the front tower. Then just drill the holes out to match the stock tower. That picture is the only one I have of my current car right now.

fhm555

iTrader: (2)

Did you run it with a spek system and a 6V regulator with no problems? What servos were you using?

bobf24

iTrader: (28)

yep, I'm using the Futaba Spektrum, both pro and standard, and with pretty much every brand of servo, the start of last year I had servo issues , so I used JR, Airtronics, Futaba, Ace, both digital and analog (in throttle), all worked fine with no issues,

they actually work better because you always have a constant 6V, it never drops below that like with a nimh pack

Machine's R/C H

Welcome Travis Scrambling to the Team. He will be racing the CEN Matrix for the 1st time this weekend at the FSORS and then at the AIC next weekend. Travis was on the 2004 ROAR USA Ifmar Worlds Team in Sweden before he took a break from racing.

lockmouth

iTrader: (33)

Gene, the CEN TEAM is growing fast Look like CEN will be in the house deep at the AIC 5.0

Cain

iTrader: (294)

One of the big reasons I went with a CEN. They really are serious about there racing team and have amazing customer service.

Machine's R/C H

We down sized the team a lot from last year, but we are adding a few good drivers here and there to replace Jason Ashton. This is only CEN Racing's 2nd year having a race team. Their 1st pro kit did not come out until 1 year ago - March of 2006 - The Matrix Pro FRE.

Cain

iTrader: (294)

Here is a pic of my matrix, prior to adding in my red CNC parts with my SB V2 buggy.

odoylrulz

iTrader: (13)

nice car cain, check mine out

Cain

iTrader: (294)

Very nice looking!

I got my Ecktec rear hingepin stuff in. Looks to be in great shape and I got it used or about $15 shipped!