F1RCGP Series Round 8 at TQ RC RACING.
07-25-2013, 06:46 PM
#1
F1RCGP Series Round 8 at TQ RC RACING.
F1RCGP Series Round 8 will be held on Aug 17th.
Click here for the rules, registration forms.
For more information, please visit http://www.f1rcgp.com/ http://www.sscc-gt.com/
Click here for the rules, registration forms.
For more information, please visit http://www.f1rcgp.com/ http://www.sscc-gt.com/
08-02-2013, 02:34 PM
#5
Too bad this race was scheduled the Saturday before the Tamiya Nationals. Sadly I won't be able to make it as I will be preparing for GT1. I hope Hideo comes back again during the UF1 Winter Season as I want a rematch from our very close battle last season!
The layout this weekend looks very much like the layout we ran that weekend
The layout this weekend looks very much like the layout we ran that weekend
08-02-2013, 11:12 PM
#10
What's the suggested foam tire to use for 200mm F103? Is Zen the best one? Not sure about my schedule yet, but if possible, i'm looking forward to racing with the guys from Japan.
08-02-2013, 11:44 PM
#12
Hrm.. brilliant of me. It does say controlled tire in the flyer doesn't it? Thanks Charles!
I understand there are some slight troubles with translating the rules? From what I can see on the F1 RCGP site, this is the setup for both 205mm classes:
F103 Front: Z9103
F103 Rear: Z9102SS
F104 Front: Z9107
F104 Rear: Z9106SS
Hey Carlos, where did you get yours?
I understand there are some slight troubles with translating the rules? From what I can see on the F1 RCGP site, this is the setup for both 205mm classes:
F103 Front: Z9103
F103 Rear: Z9102SS
F104 Front: Z9107
F104 Rear: Z9106SS
Hey Carlos, where did you get yours?
08-03-2013, 12:08 AM
#13
Oh wow, ok. Dove a bit deeper into the rules with my VERY limited Japanese. Here are the specs for F1 Foam 205mm class
Weight: At least 980g; race ready
Motor: Silver Can RS-540SH or 21.5T
Gearing: 93T Spur/25T Pinion (really?)
ESC: Commercially available ESC in blinky
Battery: 2S LiFe or LiPo
Tire: Controlled Tires as follows
Body: Must be painted. Driver figure must be attached & painted in two colors (?). Tires must be visible from above.
Race format: 4 minute qualifier. 8 minute main. Staggered start for qualifiers. Main order is max 10 cars determined by best 3 scores of 4 qualifiers. B main and lower is max 14 cars. (this MIGHT need to be amended for TQ
)
Prohibited: No sauce(!). Tire truing is permitted.
Weight: At least 980g; race ready
Motor: Silver Can RS-540SH or 21.5T
Gearing: 93T Spur/25T Pinion (really?)
ESC: Commercially available ESC in blinky
Battery: 2S LiFe or LiPo
Tire: Controlled Tires as follows
- F103 Front: Z9103
- F103 Rear: Z9102SS
- F104 Front: Z9107
- F104 Rear: Z9106SS
Body: Must be painted. Driver figure must be attached & painted in two colors (?). Tires must be visible from above.
Race format: 4 minute qualifier. 8 minute main. Staggered start for qualifiers. Main order is max 10 cars determined by best 3 scores of 4 qualifiers. B main and lower is max 14 cars. (this MIGHT need to be amended for TQ
)Prohibited: No sauce(!). Tire truing is permitted.
Last edited by silencery; 08-03-2013 at 12:19 AM.
08-03-2013, 09:57 AM
#15
Half time. The Zens I used where old inventory from before TQ. New i package fronts labeled 38 rears 30.for out door intention. Fronts harder than rear. Hight started at 5mm no tire trueing. Jack full rear half on front. Silver can 96/31.7 mnts and motor was 163 and com was 203 and smelled bad.
Last edited by xsracer; 08-03-2013 at 10:43 AM.