Ofna Ultra GTP2e
#1321
Tech Initiate
#1327
Tech Adept
yeah i definitely notice the front bumper scrubbing. it will act as a skid plate of course but it certainly limits some suspension travel sticking down a good 1/4"
or so. What is involved in the DM1 bumper mod?
Here's some pics of how it is sitting right now. The body is just under level with the chassis, i have a bit of room to trim if needed.
or so. What is involved in the DM1 bumper mod?
Here's some pics of how it is sitting right now. The body is just under level with the chassis, i have a bit of room to trim if needed.
But even then I run my DM1 bumpers lower ,and actually ground them down to make it not stick out past the 2mm titanium brackets I made
#1329
Tech Adept
#1330
Tech Master
iTrader: (16)
Cool, gives me something to tinker with. SNR can keep the chassis.
That would be a completely pointless purchase just to mount a diffuser out back lol. For me anyways.
Fab job it is
If i can put a GTP2e bumper on my ERBE, im sure i can figure out a piece or something to mount the diffuser haha
That would be a completely pointless purchase just to mount a diffuser out back lol. For me anyways.
Fab job it is
If i can put a GTP2e bumper on my ERBE, im sure i can figure out a piece or something to mount the diffuser haha
#1331
Tech Adept
Cool, gives me something to tinker with. SNR can keep the chassis.
That would be a completely pointless purchase just to mount a diffuser out back lol. For me anyways.
Fab job it is
If i can put a GTP2e bumper on my ERBE, im sure i can figure out a piece or something to mount the diffuser haha
That would be a completely pointless purchase just to mount a diffuser out back lol. For me anyways.
Fab job it is
If i can put a GTP2e bumper on my ERBE, im sure i can figure out a piece or something to mount the diffuser haha
front
rear
If you run regular sway bars you can make something that goes under the diff housing under the front lower pin plate I would then brace it for protection, and keep it from flexing under impact
With the blade/torsion sway bars I would need a slitting saw to do it the way I want.
Use Titanium, stronger then aluminum and lighter then steel, grade 4,it's not hard to work with at all, easier then stainless to me.
#1332
Tech Addict
iTrader: (9)
RX8 2250kv 24T pinion
4S very fun
6S OMG, there may as well have been jet engines with after burners. Caught a bump and it was hydroplane airtime, OFNA tires without belt....torn to rags. Installed 50sh Sweep slicks, good to go. Garmin Forerunner 301 said 60.3 MPH, I think it could go closer to 80Mph on a better stretch to let it wind out. Eagle Tree logger reports temps aren't even getting hot, mind you it was 6 degrees celsius. The car is deadly, 4PL controls it perfect HS-7945TH steers it with excellent reponse. No complaints.
4S very fun
6S OMG, there may as well have been jet engines with after burners. Caught a bump and it was hydroplane airtime, OFNA tires without belt....torn to rags. Installed 50sh Sweep slicks, good to go. Garmin Forerunner 301 said 60.3 MPH, I think it could go closer to 80Mph on a better stretch to let it wind out. Eagle Tree logger reports temps aren't even getting hot, mind you it was 6 degrees celsius. The car is deadly, 4PL controls it perfect HS-7945TH steers it with excellent reponse. No complaints.
#1334
Tech Initiate