Picco 2011 TORQUE onroad engines
#166
Tech Addict
New Picco .21
Hello everyone, I just received my Picco Torque .21 EDO motor. Should I add a Shim for 25% Nitro and also do i have to use a washer under the plug? Thanks in advance.
#167
Is your track small, keep it as it is, if the track is bigger, add 0.1mm.
and also do i have to use a washer under the plug? Thanks in advance.
NO!...
These plugs are so called "turbo" plugs, they have a conical end.
#169
Tech Addict
Ok Thanks for the info. I had an old picco plug that did'nt seem to seat right. But I have never used a washer with a "turbo plug". Will order new plugs. Thanks!
#170
anyone know what the differences are in these two manifolds that come with the picco 2033 pipe http://www.rc-mushroom.com/product_i...ducts_id=20270 and http://www.rc-mushroom.com/product_i...ducts_id=20158 thanks
#171
Tech Addict
anyone know what the differences are in these two manifolds that come with the picco 2033 pipe http://www.rc-mushroom.com/product_i...ducts_id=20270 and http://www.rc-mushroom.com/product_i...ducts_id=20158 thanks
#172
Tech Addict
#173
Tech Addict
Any shop in USA selling the new Picco engines? How come I still don't see any, it has been released like over a month already? The new Nova is too expensive now. I want to get something cheaper in price at the same fast performance.
#174
#175
The Picco Torque .21 engines are in stock now.
#176
Tech Champion
iTrader: (91)
Superior Hobies Instock
The .21 Picco Tq Edo Modified Power Pack are in stock .12 on arrival
http://www.superiorhobbies.com/istar...&id=PIC9231!SH
http://www.superiorhobbies.com/istar...&id=PIC9231!SH
#177
whats factory needle settings for the .21 ?
#178
A good base setting for the .21 Torque is as follows.
High Speed Needle = 3 turns out
Low Speed Needle = 4 turns out
This is flush with the housings on both needles.
The factory settings are 1/2 turn leaner than what I have listed above.
For break in, I would start 4 turns out on the LSN, adn 4 turns out on the HSN.
High Speed Needle = 3 turns out
Low Speed Needle = 4 turns out
This is flush with the housings on both needles.
The factory settings are 1/2 turn leaner than what I have listed above.
For break in, I would start 4 turns out on the LSN, adn 4 turns out on the HSN.
#179
Technical Support
Please feel free to direct any technical support questions regarding the Picco Torque engines to me. You can contact me at the following email address, or just ask on this thread.
[email protected]
or
[email protected]
[email protected]
or
[email protected]