MTclassPro

iTrader: (33)

I thought I would post ths because I took my engine apart to get ready to put in the new bearing that I had ordered and I came across the play that was noticeable and I posted here for some peoples responses.

http://www.youtube.com/watch?v=tpgi65YpDOk

Thanks, all comments are welcome

gkn0315

iTrader: (126)

whats the crank pin look like and is there play there as well

MTclassPro

iTrader: (33)

Do you mean the crank shaft pin where the con rod hole sits in?

MTclassPro

iTrader: (33)

no?

McFly505

iTrader: (13)

That rod is DONE, time for a new one.

EDIT--I'd replace the pin, as well.

MTclassPro

iTrader: (33)

Heres a pic yes its big and it takes up half the page, but youll see it better.



More to come

MTclassPro

iTrader: (33)

Come on guys.

hambone

iTrader: (1)

It's shot, period. It needs a piston, sleeve and rod at least. Crank pin probably gone too. Buy a new engine. They are inexpensive and disposable.

Alan D.

You need a new rod. I would also get a new wrist pin and eclips while you are there. May want to try and contact customer support and see if they can help you out.

MTclassPro

iTrader: (33)

Yeah I just did Alan.
Guess i will never buy a Dynamite motor again Ill stick with mugen and OS

Integra

iTrader: (8)

Motor specs are Pretty Dead On now a days with all the technology we have access to....and to call out the mfg on a defect that was more then likely user error isn't the right way to go about it.

Alan D.

Mistakes are possible. You know that.