DF-03RA WRC wip
#31
If you intend to jump with that car I think it would be a good idea to bump the body up higher a bit otherwise I don't see the front spoiler lasting too long.
#32
DONE 8)
all wired-up, 3 packs later clean again
#34
Tech Elite
iTrader: (51)
are you guys using the kit supplied 90wt oil? I put 45 in all 4.
how does it feel with the 90? I know tamiya Always does their homework on set-up. I did not notice the weight until I looked at the bottle and then checked the manual. all 4 were already built . Thanks, fat
how does it feel with the 90? I know tamiya Always does their homework on set-up. I did not notice the weight until I looked at the bottle and then checked the manual. all 4 were already built . Thanks, fat
#35
Tech Elite
iTrader: (51)
here it is The 45 did not work well so i put 80wt and much better now.
The brushless set up below will not fit in the car with out modding the chassis or sticking the speedo wayy up high. I am using a dark impact body as a inner body so i have to keep the electronics low in the chassis.
enjoy I will update on the driving/jumping when the rain lets up at my local track
The brushless set up below will not fit in the car with out modding the chassis or sticking the speedo wayy up high. I am using a dark impact body as a inner body so i have to keep the electronics low in the chassis.
enjoy I will update on the driving/jumping when the rain lets up at my local track
Last edited by fat500; 07-22-2010 at 03:09 PM.