On-Point Racing
#136
Thanks!!!
#137
Tech Master
iTrader: (2)
Couple of questions ..
1. If you were to build one up from scratch, would you prefer the AE or Serpent kits?
2. What shock is that in the AE pic? looks like a silva but not quite sure
3. Do you need offset hubs to help center the axle?
4. Can you tilt the servo upward (does it hit the top deck) or is the intended configuation to have it flat on the chassis?
5. Are there any holes drilled out for battery positioners?
Sweet looking car.
1. If you were to build one up from scratch, would you prefer the AE or Serpent kits?
2. What shock is that in the AE pic? looks like a silva but not quite sure
3. Do you need offset hubs to help center the axle?
4. Can you tilt the servo upward (does it hit the top deck) or is the intended configuation to have it flat on the chassis?
5. Are there any holes drilled out for battery positioners?
Sweet looking car.
#138
Couple of questions ..
1. If you were to build one up from scratch, would you prefer the AE or Serpent kits?
2. What shock is that in the AE pic? looks like a silva but not quite sure
3. Do you need offset hubs to help center the axle?
4. Can you tilt the servo upward (does it hit the top deck) or is the intended configuation to have it flat on the chassis?
5. Are there any holes drilled out for battery positioners?
Sweet looking car.
1. If you were to build one up from scratch, would you prefer the AE or Serpent kits?
2. What shock is that in the AE pic? looks like a silva but not quite sure
3. Do you need offset hubs to help center the axle?
4. Can you tilt the servo upward (does it hit the top deck) or is the intended configuation to have it flat on the chassis?
5. Are there any holes drilled out for battery positioners?
Sweet looking car.
2. What shock is that in the AE pic? looks like a silva but not quite sure, Hotbodies.
3. Do you need offset hubs to help center the axle? Not unless you use Xceed or crc rear tires. Jaco/parma/mobgum you dont need the off set hub.
4. Can you tilt the servo upward (does it hit the top deck) or is the intended configuation to have it flat on the chassis? Its intended to sit flat.
5. Are there any holes drilled out for battery positioners? In the production chassis there will be locating holes for a 3mm screw and nut to keep the battery from moving round.
Thanks!
Last edited by chicky03; 09-23-2011 at 11:28 AM.
#139
What pivot ball do you use to mount the front of Hot Bodies shock? I tried to put one on my 120L and had to sand down the all to free it up. Hurry up with the kits, I want one NOW11
#141
Last edited by chicky03; 09-23-2011 at 11:29 AM.
#142
Chicky beat me to the answer
#144
Tech Champion
Which body posts are those shown on the OP12C? I remember ones a long time back that looked like that but had a slot in the bottom for a small metal nut in the base of the body post. I've been looking for that type of body mount for a long time. I always seem to strip out the plastic ones.
#145
Tech Elite
iTrader: (101)
Which body posts are those shown on the OP12C? I remember ones a long time back that looked like that but had a slot in the bottom for a small metal nut in the base of the body post. I've been looking for that type of body mount for a long time. I always seem to strip out the plastic ones.
The body mounts that had little square nuts that you inserted into them were Corally body mounts.
Steve
#146
#147
Looks like last week of Sept everything should be ready to go.
#149
#150