Reflex Suspension Dynamics (RSD) TC6 Upgrades (vertical ball studs, pistons,etc)
#2269
Tech Regular
what are the rates of the old rsd spring set that was offered for the tc6?
going to try my spec r r1 on asphalt for the first time tomorrow, will start with std springs but want to try rsd springs too.. any good idea what springs to try first? low/med asphalt, car is setup almost std, just more flex added to topdeck and chassi
going to try my spec r r1 on asphalt for the first time tomorrow, will start with std springs but want to try rsd springs too.. any good idea what springs to try first? low/med asphalt, car is setup almost std, just more flex added to topdeck and chassi
#2271
Tech Regular
oooh good stuff!
#2273
Tech Regular
iTrader: (17)
Hey folks, has anyone had an issue with RSD AE TC6.1 Dual Cardan Joint V2narrow axle (RSD070)? The retainer clip on one came off after just two laps on the track. I made sure to separate the longs from the shorts, and crimped them exactly like the website showed. All 4 snapped in tight so I don't see where there could have been an error in installation. Any ideas?
#2274
Tech Fanatic
iTrader: (7)
Hey folks, has anyone had an issue with RSD AE TC6.1 Dual Cardan Joint V2narrow axle (RSD070)? The retainer clip on one came off after just two laps on the track. I made sure to separate the longs from the shorts, and crimped them exactly like the website showed. All 4 snapped in tight so I don't see where there could have been an error in installation. Any ideas?
#2276
Cristian, I know that the RSD DCJ V2 couplings are compatible with Xrays escs but what size roll pins does it use? If it's the 2mm which roll pin do I need?
#2277
Tech Champion
iTrader: (2)
is this all that's needed to change over my Tc6.1
http://www.reflexracing.net/RSD-20mm...T4_p_1755.html
http://www.reflexracing.net/RSD076-R...it_p_1734.html
ygpm too
http://www.reflexracing.net/RSD-20mm...T4_p_1755.html
http://www.reflexracing.net/RSD076-R...it_p_1734.html
ygpm too
#2279
Tech Elite
iTrader: (8)
Cristian,
If you feel that you can produce XRay T4 ballast weights (particularly for the middle of the car) with interesting features (like multiple screw holes for moving them forward/backward, or as an adjustable battery stop), at a more compelling price point than XRay's own parts, then please do so.
-Mike
If you feel that you can produce XRay T4 ballast weights (particularly for the middle of the car) with interesting features (like multiple screw holes for moving them forward/backward, or as an adjustable battery stop), at a more compelling price point than XRay's own parts, then please do so.
-Mike