cdelong

iTrader: (12)

no sweat. some guys have told me they use solder since it is so soft, but i don't want to risk binding anything in the engine by using solder.

i guess the advantage of using solder is that you can bend the solder into a "L" shape, and stick it in the plug hole without taking the head off.

i'll take the extra 5 minutes to remove the head twice and use the clay. i'll usually remove the sleeve afterwards to ensure no clay got stuck in any ports.

smash123

I would say the new .12 Novarossi will be hit on street during June and the price is like $270. Some have poxyed shaft included.

spenzalii

iTrader: (2)

Quick Question,

I just became the owner of a NSR12S5. Since it was used, I took it apart, chcked everything out, lubed it with after run oil and put it back together. What should be the starting needle positions on this engine? I have no idea how it was tuned and don't want to take a chance. Also, would a hot turbo plug be recommended with this engine?

teammpp

Mine was about 5 turns out on HSN and 3 turns out on LSN.

spenzalii

iTrader: (2)

Thank you. Does Palmaris have a p/s set for this engine? Just in case...

teammpp

yep. I actually run my BRB set in that case. Works great.

impalabob64

iTrader: (2)

i just dropped this motor in my fw05r, ballistic can i get some feed back on this eng. it faster than my ns3 race motor , this thing sounds like a chainsaw

Chewdogg

iTrader: (1)

Anyone know if the new nova 12's will be released before the sedan nats in July.

teammpp

The way things are going at the minute it'll be touch and go. The Team drivers havent even got theirs yet

tommi

iTrader: (7)

Hi guys, could use some help here as I haven't got any tools available with me right now. Can anyone give me the head clearance measurement for the NSR12S5 with the stock silver shim? TIA!

SalvadoriRacing

0.50mm........

you can go with a 0.10mm shim for 16 and 20% nitro......and two 0.10mm shims for 30% nitro.......

the original shim doesn't make the engine consistent.....

Marcos.J

iTrader: (239)

stock silver shim is .3mm (i think)

SalvadoriRacing

the shim is 0.30mm............the HEAD CLEARANCE is 0.50mm

cdelong

iTrader: (12)

I think a lot of people here confuse shim thickness with head clearance. They are not the same as pointed out by SR above.

You never know what your real head clearance is unless you check it. Do not just assume 0.3mm shim will do the job. Check your clearance at least once. You can calculate your clearance from there if you keep track of your shims at any given time.

tommi

iTrader: (7)

Thanks guys, appreciate your inputs.