Ryan_B

Hey guys. I was wondering if anyone knew a way to replace the wires running to the batteries and the motor on an esc that does not have external solder tabs (Novak Dually). I recently bought an onroad car, and would like to use the esc from my offroad truck, but I cut the wires shorter on my esc because they were so long, but now looking at my onroad car, I should have left them ridiculously long. Does anyone have any suggestions??

Javen13

you can open the esc up very CARFULLY and do it but the safest way to do it is to just splice extra wire on and heat shrink it if you open up the esc you can do some damage if your not carful and it voids the warrenty