JL Racing .12
#1188
Tech Fanatic
iTrader: (11)
Hey all,
Had some serious issues with my Evo 3 today.
Uhh, 1st heat it ran pretty good until I crashed and popped the axle carrier off . And from then on as soon as it fires up it sounds ok, but when you try to rev higher and higher it just sits at a flat note, like its rich but it doesnt sound like its gurgling.
It was originally to lean on the low earlier in the day but now I can barely get it to run with decent power..
Ninja Pipe and Header, #6 plug, About 23-26C roughly and it was probably mid 70% humidity today. Only had less than a litre through it.
Hope for some help/answers
Cheers,
Cameron
Had some serious issues with my Evo 3 today.
Uhh, 1st heat it ran pretty good until I crashed and popped the axle carrier off . And from then on as soon as it fires up it sounds ok, but when you try to rev higher and higher it just sits at a flat note, like its rich but it doesnt sound like its gurgling.
It was originally to lean on the low earlier in the day but now I can barely get it to run with decent power..
Ninja Pipe and Header, #6 plug, About 23-26C roughly and it was probably mid 70% humidity today. Only had less than a litre through it.
Hope for some help/answers
Cheers,
Cameron
#1194
Have you tried leaning the high end? Try it and keep an eye on the temps, and make sure you got plenty of smoke.
Just because its not gurgling doestn mean its not rich, it might be a tad rich. Just run the car for at least 2 minutes, and then start leaning it 1 hour at a time.
Just because its not gurgling doestn mean its not rich, it might be a tad rich. Just run the car for at least 2 minutes, and then start leaning it 1 hour at a time.
#1199
Tech Addict
iTrader: (5)
Thanks Jason
Last edited by jscamry; 02-13-2008 at 08:39 AM. Reason: spelling
#1200
Tech Master
iTrader: (21)
As you posted this, it made me wonder why my nova based header does not fit snug with my gasket that was included for the reddot. With the silicone rubber piece that was connected to carb screw and nut;do I use this in place of the gasket that came with the engine or use both the rubber piece and gasket?
Thanks Jason
Thanks Jason