STS .28 pull-start engine
#616
Kemorc posted this
"Some of you dono that STS has a new mill coming out, I think you'll be fans of it. its a 5 port .28 "
but i don't know if this is what you are talking about
"Some of you dono that STS has a new mill coming out, I think you'll be fans of it. its a 5 port .28 "
but i don't know if this is what you are talking about
#617
yep that appears to be the one I read about. I really like my current STS .28 but on the long straight at my local track it has a hard time competing with most other engines. I have the 7mm carb insert in so I'm sure that some to do with it.
#618
Tech Master
Have you tried gearing it up any jcchase ?
#619
Originally Posted by davo798
Kemorc posted this
"Some of you dono that STS has a new mill coming out, I think you'll be fans of it. its a 5 port .28 "
but i don't know if this is what you are talking about
"Some of you dono that STS has a new mill coming out, I think you'll be fans of it. its a 5 port .28 "
but i don't know if this is what you are talking about
That is indeed the engine I'm talking about... We should be getting them this month.
Last edited by Kemorc; 06-01-2007 at 01:01 PM.
#620
Next time I race I'm going to try a 14 tooth clutch bell. I originally had a 13 tooth clutch bell on it then I went down to a 12 tooth to get better throttle response for the close spaced jumps. Our front straight is 160 feet but we have alot of jumps.
That looks like a very nice engine. any idea on the price it will cost? And will it come with a roto start?
That looks like a very nice engine. any idea on the price it will cost? And will it come with a roto start?
#621
as far as i know, the engine doesn't even have a name yet. BUT... its rumored to ONLY be selling with a standard backplate. Price is unknown at this time. But I'll definitely be finding out sometime soon
#622
does anyone have the new .28 yet?
#624
last time i checked, it was not out to the public yet. it is, however, being tested by a few drivers here in the states.
#625
ah yes... they are finally making their debut on my site! the new D28M 5-Port Competition Race Engine. These things should start becoming more and more popular in the next 2-3 weeks.
#626
has anyone heard anything about them yet?
#628
yep, he's my distributor.
#629
i need a little help. i took my engine apart and wasn't paying attention. does the cut out on the piston face the carb. i looked at the manual but it is hard to tell. thankyou
#630
Tech Master
Did you take the conrod off also? if not just point the oil hole towards front of engine. Normally the longer side of the piston "skirt" goes to the rear to cover the exhaust port during TDC.