TLR 8IGHT E 3.0 THREAD
#1531
Many will say you need a high c rating, the truth is you don't. I will be running the ecopower 4100 4s with 35c rating. 12 minute run time and only 54 bucks at amain. 2-2s will fit if you lay them on there sides with the bullets parallel to the chassis. I ran nanotech 5600s with a tq side bullet as the jumper wire.
#1532
Tech Elite
iTrader: (19)
Many will say you need a high c rating, the truth is you don't. I will be running the ecopower 4100 4s with 35c rating. 12 minute run time and only 54 bucks at amain. 2-2s will fit if you lay them on there sides with the bullets parallel to the chassis. I ran nanotech 5600s with a tq side bullet as the jumper wire.
What shock oils would you reccomend for a good overall starting point? I only have ae oils and i've heard they differ a bit in viscosity compared to losi oils. Thanks.
#1533
Tech Adept
iTrader: (4)
Center Diff Play
What is the recommended center diff play (forward/rearward) not teeth mesh?
The total play is 1mm on mine. It is one month old. 3 days at the track. I built it to the book with shim/spacers. I am cleaning it and noticed alot for front to back play. No issue on the track yet, but wondering.
Thanks,
Turbo
The total play is 1mm on mine. It is one month old. 3 days at the track. I built it to the book with shim/spacers. I am cleaning it and noticed alot for front to back play. No issue on the track yet, but wondering.
Thanks,
Turbo
#1535
#1538
Tech Apprentice
iTrader: (2)
What is the recommended center diff play (forward/rearward) not teeth mesh?
The total play is 1mm on mine. It is one month old. 3 days at the track. I built it to the book with shim/spacers. I am cleaning it and noticed alot for front to back play. No issue on the track yet, but wondering.
Thanks,
Turbo
The total play is 1mm on mine. It is one month old. 3 days at the track. I built it to the book with shim/spacers. I am cleaning it and noticed alot for front to back play. No issue on the track yet, but wondering.
Thanks,
Turbo
EDIT: I just found TLR242008 - shim and spacer set
Also switched from the plastic to metal spur...totally different sound! I hope it grows on me.
Last edited by Deacon_8T; 03-15-2014 at 04:42 PM. Reason: Added tlr242008
#1539
I've got at least 2mm of play in my center diff. It walks back and forth a bit and doesn't seem normal. How much play should there be? Should the center diff be shimmed at all?
Also switched from the plastic to metal spur...totally different sound! I hope it grows on me.
Also switched from the plastic to metal spur...totally different sound! I hope it grows on me.
#1541
Here is a conversion chart:
#1543
I have a small issue/problem. My rear gear box is smooth until I get to a small section of the crown gear, it gets very rough and binds a tiny bit. Will this "wear" in or should I pull it apart? I ran it in my driveway, I still feel it when I free spin the drivetrain.
#1544
Yeah, this will wear in some.
#1545