Dragonfire

iTrader: (1)

Alot of people have mentioned it is quite short.... I was thinking of testing it longer and longer as it has a fair bit of adjustment but right now I have the rear at full length to give a bit more weight over the front.

cheehtae

iTrader: (15)

where do you guys buys your spares at?

RC MARKET

iTrader: (12)

Metal Cell Support for S411

RC MARKET

iTrader: (12)

We had support 95%+ parts keep stock !
http://rcmarket.com.hk/index.php?cPath=51_98_156_319

gearhead_22

iTrader: (10)

ok serpent the nats are next week, I would like to have some parts for back up here in the US. I ran the car this week and it held up very well,everyone at the track was waiting for it to break, fooled them even when I was slamed it to a wall by another driver it stayed together. I liked the way the bottom bummper was made. I give the car an a++++++++++++++++++. Now can we get some parts. thank you very

Jamison R

iTrader: (66)

I really wanted to try front gear diff. Ordered gear diff from RcMarket and here is retrurn email. Serpent says there is no revision to diff case. RcMarket says different:

Dear Sir,

Your orders we'll processing.

you ordered ( SERPENT 401383 GEAR DIFF SET ) this item will delay release.
because Manufacturer they need change (this item the " case ") ,
so, their shipment will delay arrive.


When we receive this item, we'll send orders to you, OK ?


Best Regards,
www.rcmarket.com.hk
Thank you for choosing RC Market!

mattwoodcraft

iTrader: (10)

im getting some of these battery straps the alloy ones good thing.

i have seen the gear diffs in the front of the serpents all ready here running about

Jamison R

iTrader: (66)

How do you like the front gear diff?

Jamison R

iTrader: (66)

Not the gear diff. It says in stock, but its not. Read my above post

gearhead_22

iTrader: (10)

I placed an order form them yesterday and I was going to order that part gald I didn't I would be really

snoopyrc

iTrader: (2)

Did we ever figure out what parts will support the S400 from the S411? Can I use arms and C hubs and steering knuckles? How about Belts and CVD's?

Or can I get parts for the S400 again?

gearhead_22

iTrader: (10)

I have both cars and the s411 takes a smaller outer bearing on the steering knuckles and cvd. now if you can put the hole arm, c hub, and all on it i haven'ttried it yet, but to me it look like it fits.

JayBee

iTrader: (31)

So since these cars are a bit shorter, how are you guys mounting your bodies?

corallyman

iTrader: (101)

JayBee,

My LW LTC-R mounted just fine, Kody actually did it and it went smooth as buttahh. I actually have removed 1mm shim from behind the front arm, moving the arm towards the motor (shorter) and I moved 2mm of shims in front of the rear arm, thus moving the rear arms away from the motor.

My car is really good on its first and only run (dang rain out last week).

Steve

grippgoat

iTrader: (8)

No kidding.

-Mike