Xray T4'14
#196
Tech Elite
iTrader: (5)
I pre-ordered my T414 today (I like calling it the T414 LOL), Australian stock I think is due Monday or Tuesday, looking forward to getting it, really looking forward to the build, and getting a much closer look at what I think is going to be a fantastic toe/roll design.
#197
#198
#199
This is the clearance with my rod ends;
Completed at last;
Using the lower hole in the servo saver I get 24-25deg steering on both sides, despite the fact I had to increase the EPA to increase the motion.
Completed at last;
Using the lower hole in the servo saver I get 24-25deg steering on both sides, despite the fact I had to increase the EPA to increase the motion.
#200
You're front bulkheads are missing a few screws Or is that on purporse?
#201
#202
#203
oh and heres one for ya,since i ran mine its developed a small amount of slop in the rear uprights,they move forward and back on the pivot pins,is this something that needs shimming?at a guess id say a 0.3 shim should make it snug again,but is it worth doing?
#204
yeah,epa is at 120 and all measured with digital calipers,the links are spot on,i moved the saver around a few times and go nowhere,ive got it turning the same amount each way so alls good,if i suffer from a lack of steering ill work more on set up
#205
#207
Did you put the servo saver in the top hole? If I use the lower hole I can't get full throw. The barrel is no where near hitting. Prob a 2-3 mm gap at full throw. Moved it up and had to take 20% of dual rate out of my radio and backed 10% of EPA out of both sides. More steering than I needed..lol
#208
First time I bought an Xray kit that came with them I fitted them, Broke one on the very first run.
Just something else to stick out and make contact with the ground.
Last edited by Skiddins; 10-10-2013 at 10:01 AM.
#209
My Sanwa BLS (with the link in the lower hole on the servo saver) can give me more than enough lock and I'm not at 100% on the radio.
It's circa 27deg on the inside and 19deg on the outside wheel when running around 0.5deg toe out.