LOSIRACER77

iTrader: (2)

That gives me a woody!!!!!! I wish I had the parts effort the weekend.

TeckLancer

iTrader: (16)

hey casper do u know when horizon hobbies wil be getting more 2.0 e's in. i stripped my 1.0 down and have it for sale but hopefully they are there before the next jbrl in bakersfield

Casper

iTrader: (34)

They say 6/15 right now but not sure how accurate that is and is only 5 days before the JBRL which is not a lot of time to get in stock and shipped.

DG Designs

iTrader: (14)

Should have my buggy next week. running a 1900 tekin on 4s with a 45 spur, what should i be running for a pinion? want to make sure heat is not an issue.

TeckLancer

iTrader: (16)

i run my xcelorin 1700 system with a 4 cell and i run 45 spur 15 pinion for smller tracks and on bigger 1/8th scale tracks i run a 16 tooth

DG Designs

iTrader: (14)

thanks, one of these days i want to try a 1700 or even lower, definitely dont need the 1900 around here

Casper

iTrader: (34)

I would start between 14 and 15.

DG Designs

iTrader: (14)

Who makes a 14.5?

Bman's 3XNT

iTrader: (71)

I run a 15t and even bumped up my timing 5-10*. Motor runs 135-150F.

morgoth

Hi guys,

I'm running a converted 1.5 8ight with the original motormount. But every time I race it my mesh is looser. I need to reset it every 2-3 races... The bolt is tightend really good and I did threadlock in it, but nothing seems to help.

I'm running a 2200kv castle neu with the motor brace (which I had to modify a bit) geared 14/48 or 13/45. Stripped my delrin spur last weekend, because my moved away from the spur...

Do you guys have a fix for this? Also sometimes is hard to get the motor out of the mount when I drove it a few times without taking the motor out every time...

Jube

iTrader: (43)

I despise the motor brace that is on the chassis at the rear of the motor. I never run it. Chassis flexes and hits the rear of re motor putting everything in a bind. Just my opinion.

morgoth

I run it since I stripped my spur last weekend. I tought the mount was comming lose because of the big hits with the ground. Also, some of my finns from my motorcan were damaged because they hit the chasis without the brace
There seems to be no difference between running a brace or without. The mesh always comes a bit looser.

Jube

iTrader: (43)

Ok then run the chassis motor brace.

morgoth

Can I ask you what motor your running? The 1515 1.5Y is pretty heavy compared to a tekin buggy motor. Maybe that makes a difference too. I think I'll buy a neu 1512 of a tekin motor/combo next month.

But does your stays good, or do you need to reset very often?

blade329

iTrader: (114)

Don't use the motor brace. Even the Losi guys say to take it off. That is the cause of a lot of stripped spur gears and loose motor mounts.