Hpi Pro 4
Actually just checked the TCX manual and the Pro4 shares the same C-hub. I received a Spec R DCJ set but at first glance didn't look like it will fit. I guess I'm wrong. Will install tonight.
I have the Spec R DCJ for the TCX. It will fit whether you run the ball diff or spool.
Tech Rookie
Anyone know a place that has the Spec-R DCJs in stock then?
Tech Master
My tamiya DCJ'S worked when I ran a TCXX. So tamiyas should work for your car as well.
Tech Master
Tech Champion
iTrader: (15)
Tech Rookie
NEWS NEWS NEWS
First News......
Search in FaceBook.......Hpi pro4 lovers.....
Is a Pro4 lovers, is a new page, send your pictures, trick, opinion....
Second news.......
Italian RC have in processing a new Lipo Chassis e topdeck for HPI pro4, with a news solution and........gear diff!!!!!
Ivan
Search in FaceBook.......Hpi pro4 lovers.....
Is a Pro4 lovers, is a new page, send your pictures, trick, opinion....
Second news.......
Italian RC have in processing a new Lipo Chassis e topdeck for HPI pro4, with a news solution and........gear diff!!!!!
Ivan
Tech Master
Top DCJ's are 46mm and will work as well
Tech Elite
iTrader: (66)
Gear diff!!!??? If true thats mighty tempting to hunt a couple more down and get back into the shaft drive game.
PRO4x LIPO CHASSIS version 2
preview is finally up on Exotek website. Just my pre-order in!
preview is finally up on Exotek website. Just my pre-order in!
Pre-ordered too. Curious why the motor was switched to the other side? The reason for this?
Very tempted for one of these - could then give the car to my son to drive. I think the motor is on the other side in an effort to reduce torque steer.
Tech Elite
iTrader: (66)
I wonder if exotek is going to make lower towers to go with the TCXX low pro shocks?