snowboard094

iTrader: (5)

http://www.thebarnfloor.com/catalog/...oducts_id=1439
I was considering this motor as a replacement for my original 3.3. The truck it is going in is a slayer. Does anybody know much about this motor? Is is based off the mach .26? I know the mach motors are very reliable and put out good power so i thought that it would be ideal for this application. Last of all what pipe and clutch setup do you guys recommend me running?

Thanks

snowboard094

iTrader: (5)

ttt

token

That Engine will be fine in the slayer - a little more power than a 33

snowboard094

iTrader: (5)

is the crank the same length as the mach .26, because i know for a fact that the .26 works with the new era BB kit? Pipe?