spur gear
#1
Tech Fanatic
Thread Starter
spur gear
hey folks....
i tested some spur made by robinson racing.....they seem to be good, very thin, I ran the spurs and I liked....
my doubt is about the shape of these spurs, they're bent from the factory, all my spurs are warped.....does it affect on friction, etc???
thanxx....
i tested some spur made by robinson racing.....they seem to be good, very thin, I ran the spurs and I liked....
my doubt is about the shape of these spurs, they're bent from the factory, all my spurs are warped.....does it affect on friction, etc???
thanxx....
#2
hey,
Ive run them as well, they do seem to be slghtly warped but so have the others i have used, but the robinson racing ones are good and reliable, i dont think that it will affect friction but i could be wrong, as long as its only slight warp.
it could also be that it might of been thightened up to much on one side?? just something to think about
anyway good luck hope this helps
J-P
Ive run them as well, they do seem to be slghtly warped but so have the others i have used, but the robinson racing ones are good and reliable, i dont think that it will affect friction but i could be wrong, as long as its only slight warp.
it could also be that it might of been thightened up to much on one side?? just something to think about
anyway good luck hope this helps
J-P
#3
Tech Fanatic
Thread Starter
I think not, because the original Xray spur was tightened as I did with the robinson ones.....
I didn't see any bad effect on my car, but I'm curious about the shape of the spurs...
I didn't see any bad effect on my car, but I'm curious about the shape of the spurs...