Soldering/Connecting 13.5T EZ Run V2 to ESC
03-06-2012, 05:27 PM
#1
Soldering/Connecting 13.5T EZ Run V2 to ESC
Hi There!
I have a TA05 VDF and got an EZRun V2 13.5t brushless.
Do I just solder the ESC wires directly into the "half bullet connectors" on the motor or do I need to get male bullet connectors to slot in. If so what size?
Many Thanks!
I have a TA05 VDF and got an EZRun V2 13.5t brushless.
Do I just solder the ESC wires directly into the "half bullet connectors" on the motor or do I need to get male bullet connectors to slot in. If so what size?
Many Thanks!
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
