Trinity duo3.5 new motor
#286
Tech Champion
iTrader: (34)
Of course I can do that, I've been doing this a long time, but other racers running other cars get prompt answers and 1/12TH gets NO answers at all except "figure it out guys". I realize we are a small minority in the grand scheme of RC, but it would be nice not to be ignored.
We've been running 85mm to 90mm at TQ, and 90+ outdoors with 13.5 blinky, timing around 20+ from neutral
Haven't run a D3 or 3.5 yet, this is with "other motors"
13.5 blinky is a fairly new class for 12th, so not a lot of info on roll out there yet
#287
Tech Elite
iTrader: (8)
Of course I can do that, I've been doing this a long time, but other racers running other cars get prompt answers and 1/12TH gets NO answers at all except "figure it out guys". I realize we are a small minority in the grand scheme of RC, but it would be nice not to be ignored.
A lot of people are running the motor in 12th scale. Just ask and see what responses. A lot of people are still testing this motor too.
#289
Tech Elite
iTrader: (8)
Yeah I heard a few people did that with the xray. All I am saying is that the motor wasnt sold to 12th scale 17.5 and 13.5 as much as touring car and from what I heard timing, rotor, gearing etc changes. I know people are testing it although I'm sure the results are more than likely going to be passed over until after the 26th cause I know that there are a few people like Blake who only has minimal testing on his 12th scale.
#290
I have been reading this thread since it opened, several people have asked if anyone could put them in the ballpark on set up for 17.5 and 13.5. I don't recall a single answer until Dave jumped in a couple posts back. And his info was not specific to the 3.5. This is not an issue unique to Trinity/Epic, just annoying from a company that made it's rep in pan car.
#291
Of course I can do that, I've been doing this a long time, but other racers running other cars get prompt answers and 1/12TH gets NO answers at all except "figure it out guys". I realize we are a small minority in the grand scheme of RC, but it would be nice not to be ignored.
#292
Team EAM
iTrader: (79)
I have been reading this thread since it opened, several people have asked if anyone could put them in the ballpark on set up for 17.5 and 13.5. I don't recall a single answer until Dave jumped in a couple posts back. And his info was not specific to the 3.5. This is not an issue unique to Trinity/Epic, just annoying from a company that made it's rep in pan car.
I'll be back running on the carpet in the next week or so and will get you a good ballpark for carpet with the D3.5 motors. I have not gotten to run one yet but I know the TC guys have been 2-3 teeth bigger on the pinion with the D3.5's than they were with the Revtechs. I would assume the same would hold true in 12th scale. Timing on TC has been between 18-25 degrees and depends on the motor for the blinky class in TC. Same will probably hold true in 12th scale.
EA
#293
Hey Lonny,
I'll be back running on the carpet in the next week or so and will get you a good ballpark for carpet with the D3.5 motors. I have not gotten to run one yet but I know the TC guys have been 2-3 teeth bigger on the pinion with the D3.5's than they were with the Revtechs. I would assume the same would hold true in 12th scale. Timing on TC has been between 18-25 degrees and depends on the motor for the blinky class in TC. Same will probably hold true in 12th scale.
EA
I'll be back running on the carpet in the next week or so and will get you a good ballpark for carpet with the D3.5 motors. I have not gotten to run one yet but I know the TC guys have been 2-3 teeth bigger on the pinion with the D3.5's than they were with the Revtechs. I would assume the same would hold true in 12th scale. Timing on TC has been between 18-25 degrees and depends on the motor for the blinky class in TC. Same will probably hold true in 12th scale.
EA
#297
Tech Master
iTrader: (27)
Join Date: Dec 2003
Location: im 4rm a far away place called 1st
Posts: 1,849
Trader Rating: 27 (100%+)
I just jumped ship and bought a 13.5 for blinky sedan going to be running at tq raceway med grip carpet with 90ft straight if that and Im thinking an fdr of 4.5 should be about right can anyone share what fdr their running for blinky sedan.
#298
I would start with 4.0FDR and 15+ timing for 13.5. This motor is confusing to gear correctly. outdoor medium track and im at 3.9fdr w/ max timing
#299
Tech Master
iTrader: (27)
Join Date: Dec 2003
Location: im 4rm a far away place called 1st
Posts: 1,849
Trader Rating: 27 (100%+)
#300