XXX Kinwald Edition (BK1) with GTB & 13.5
#1
XXX Kinwald Edition (BK1) with GTB & 13.5
I bought this XXX Kinwald Edition in 2005 and have run it in a handful of events, the most recent being the 2009 ROAR Nationals. It's been well kept and is not rusty. The ball diff was rebuild about a year ago, but has less than one battery worth of run on it since then. All the ball bearings are good and smooth. The body and wing aren't very good (I am not a good painter), but they are clean and quite functional.
It comes with everything the original kit came with as well as the following parts:
Team Novak GTB speed control
Losi Exceleron 13.5 brushless motor
Futaba S9451 Metal Gear Servo (0.10 sec, 121 oz-in @ 6V)
Lunsford Titanium shock mounts
Lunsford Titanium hinge pins
Lunsford Titanium front axles
Titanium top shaft (the one the spur gear sits on)
Mostly titanium ball studs throughout
Some titanium screws but mostly aluminum screws throughout
Titanium "Fat Boy" motor screws.
Losi hard anodized aluminum shock pivot balls
Trinity aluminum rear squat block
Trinity aluminum front hinge pin brace
Trinity transponder mount (like anyone uses those anymore!)
Aluminum shock collars
Losi Anti-sway bar kit
15 sets of mounted tires plus one set of unmounted tires (all tires are balanced and most are good enough to run)
Spare battery brace
Spare steering knuckles (3 sets)
Spare front carriers (2 pair)
Spare rear carriers (1.5 sets)
Spare front pivot block (2)
Spare front shock tower
Spare rear shock tower
Spare wing mounts
Spare drive shafts (stock aluminum ones, unused) + two spare CVD shafts
Spare rear A-arms (4)
Spare front A-arms (3)
Spare front axles (2)
Spare ball cups (16)
Spare spur gears (5)
Spare pinions (2)
Front springs (4 sets)
Front skid plate and upper plate
If anyone just wants the car without motor and ESC, subtract $100 off the price. Asking $250 shipped anywhere in the US. If you think that's too high, make me an offer. If you are in North AL or middle TN, feel free to pick it up (subtract $20).
It comes with everything the original kit came with as well as the following parts:
Team Novak GTB speed control
Losi Exceleron 13.5 brushless motor
Futaba S9451 Metal Gear Servo (0.10 sec, 121 oz-in @ 6V)
Lunsford Titanium shock mounts
Lunsford Titanium hinge pins
Lunsford Titanium front axles
Titanium top shaft (the one the spur gear sits on)
Mostly titanium ball studs throughout
Some titanium screws but mostly aluminum screws throughout
Titanium "Fat Boy" motor screws.
Losi hard anodized aluminum shock pivot balls
Trinity aluminum rear squat block
Trinity aluminum front hinge pin brace
Trinity transponder mount (like anyone uses those anymore!)
Aluminum shock collars
Losi Anti-sway bar kit
15 sets of mounted tires plus one set of unmounted tires (all tires are balanced and most are good enough to run)
Spare battery brace
Spare steering knuckles (3 sets)
Spare front carriers (2 pair)
Spare rear carriers (1.5 sets)
Spare front pivot block (2)
Spare front shock tower
Spare rear shock tower
Spare wing mounts
Spare drive shafts (stock aluminum ones, unused) + two spare CVD shafts
Spare rear A-arms (4)
Spare front A-arms (3)
Spare front axles (2)
Spare ball cups (16)
Spare spur gears (5)
Spare pinions (2)
Front springs (4 sets)
Front skid plate and upper plate
If anyone just wants the car without motor and ESC, subtract $100 off the price. Asking $250 shipped anywhere in the US. If you think that's too high, make me an offer. If you are in North AL or middle TN, feel free to pick it up (subtract $20).
Last edited by gte024h; 10-31-2010 at 10:13 PM.
#2
I am somewhat flexible on price, and I can remove the electronics and sell it as a roller if you want. I will sell just the roller for $130 shipped.