CVD for a old RC10 Worlds car
#3
Tech Fanatic
iTrader: (23)
you might check the measurements because the b3 ones may fit. also if you cannot find a b3 one the customworks GBX enforcer cvd's are the same as the b3.
http://www3.towerhobbies.com/cgi-bin...?&I=LXNTM2&P=7
http://www3.towerhobbies.com/cgi-bin...?&I=LXNTM2&P=7
#5
The lenght is different from a b2, and so is the diameter. Before the b2 they had 1/4 axles... b2 and after had 3/16.
Did you find one yet doc??
Did you find one yet doc??
#8
Tech Fanatic
iTrader: (23)
this is a link for some for the rc10 not sure if they fit the worlds car though.
http://cgi.ebay.com/VENTAGE-TRINITY-...QQcmdZViewItem
http://cgi.ebay.com/VENTAGE-TRINITY-...QQcmdZViewItem
#11
if your going with stock they would be universals but cvd's will work if you have the correct cvd's.
#13
FWIW, I saw a gold tub RC10 that had been converted using B4 rear hubs and CVDs. The parts fit well and it changed the rear track width to work correctly with the curret B4/XXX rear wheel offset so he can easily find wheels for the car as well as CVD parts. Seemed like a worthwhile change to me.