PPD TC setup plates. TC5, Mi3, Xray, Cyclone and ??
10-07-2008, 09:52 PM
#92
When will one come for the 416?
10-09-2008, 05:46 PM
#98
Vern....Do you have both for the t2 007eu
10-09-2008, 07:17 PM
#99
We haven't gotten to the Xray yet. I haven't decided on the 007, even though I own 2, those chassis seem fairly tweak free IMO....that said, I'm really liking setting droop on the TC5 plate, and may end up doing a few for 007. I have another non RC project that I'll have to do first, prob. be 2-3 weeks min. at this point. Keep checkin back from time to time and I'll provide updates. 
10-10-2008, 04:57 AM
#100
The lipo balance plates are those lipo manufacturer specific if so got any for the orion 3800?
10-10-2008, 11:46 AM
#101
They are not manufacturer specific. Bottom line is you'll need 1.5mm clearance over your battery to top deck and they'll fit. Thats about .060 worth of feeler gages. For the Xray EU chassis and the 3800's they work fine, although you'll want to sand the carbon humps down.
10-10-2008, 01:03 PM
#102
They are not manufacturer specific. Bottom line is you'll need 1.5mm clearance over your battery to top deck and they'll fit. Thats about .060 worth of feeler gages. For the Xray EU chassis and the 3800's they work fine, although you'll want to sand the carbon humps down.
I mounted everything up and took the small amount of rock out of a friends chassis and unhooked all the corner tabs and couldn't figure out why the chassis wouldn't come off the plate. Looked at all four clamps again and they were off but still not seperation
Then it hit me.........YOU HAVE A CENTER BRACE DUMMY!!!! What a fool!!! Great product and I will order some weights should I switch to 4000's rather than 5000's for next season.
10-12-2008, 09:35 AM
#105
[QUOTE=Verndog;4924575]They are not manufacturer specific. Bottom line is you'll need 1.5mm clearance over your battery to top deck and they'll fit. Thats about .060 worth of feeler gages. For the Xray EU chassis and the 3800's they work fine, although you'll want to sand the carbon humps down.[/QUOTE]
you mean sand them flat?????
you mean sand them flat?????