Yokomo YZ-2
|
|||
#3781
I have the 0 degree offset hubs on my car along with the 66.5mm axles. Is possible to use the schelle or MIP 67mm lightweight axles for this car? .5mm doesn’t sound like much but would like to know if anyone have tried.
#3782
Ok who here runs a 4 gear transmission, on what surface and what kind of weigh you run? Thanks
#3783
Tech Elite
iTrader: (65)
I ran a 4 gear on the original YZ2 with brass rear front suspension block and brass rear ballstud mount. Plus brass front bulkhead mount and shorty all the way back. Car was good on high bite clay. I ran it a few times on low bite dirt and it was ok but not as much grip as something like a standup rear gearbox.
#3784
I'm running on medium traction dirt/ clay mixture. Just wondering what it would be like so Sunday I ran with a 4 gear trans. I't was hard to drive but I can get faster lap times with it.
#3786
Thanks, Ill be trying the Schelle 67mm shafts. I don't think .5mm will be that much of an issue....
#3788
Quick question!
Does the wc car come with alu front upper arm mount?
Does the wc car come with alu front upper arm mount?
#3790
Tech Master
iTrader: (90)
Found this on petitrc. Shows all the wc upgrades http://site.petitrc.com/setup/yokomo...anualAddon.pdf
#3791
Tech Apprentice
my YZ2
Last edited by smrcboy; 02-02-2018 at 11:01 AM.
#3792
Tech Master
iTrader: (4)
Join Date: May 2008
Location: Formerly Portland TX, Now Amarillo
Posts: 1,242
Trader Rating: 4 (100%+)
Anyone happen to know what changes might be coming in the next YZ2? Still going to be a CA and DTM car? Looking to buy a new Yokomo but nothing available anywhere. I run on mainly black CRC carpet and attend a few races on a high bite indoor clay track. So I want to make sure to get something more suited for those.
#3793
Tech Champion
iTrader: (21)
I've used and sometimes still use it on low grip, slick astro. Run it lighter than you would the 3gear. Doing so helps with the fore/aft yaw the 4gear cars has. I don't go over a total car weight of 1540-1550g running mod with it like that. My high-grip car is sometimes north of 1600g for comparison.
#3794
Tech Legend
iTrader: (294)
alright did some assembly work here, will see how it goes for this coming race but I got the CA style rear upper mount assembly (the one with the holes all straight across) that has the weights you can add to it sitting here NIB, I was thinking of giving it a go versus the DTM style one. For current carpet setups is that one worth looking at or should I just get the DTM one in alloy?
#3795
Tech Initiate
Anyone happen to know what changes might be coming in the next YZ2? Still going to be a CA and DTM car? Looking to buy a new Yokomo but nothing available anywhere. I run on mainly black CRC carpet and attend a few races on a high bite indoor clay track. So I want to make sure to get something more suited for those.