Sheperd Velox
03-27-2008, 07:42 PM
#46
I removed a little plastic from the bottom of the rear hubs or uprights where
the pivot balls connect to the lower arms to prevent binding.Also when running the short wheel base you might need to remove just a little plastic
where the front swaybar mounts touch the bulkhead.
the pivot balls connect to the lower arms to prevent binding.Also when running the short wheel base you might need to remove just a little plastic
where the front swaybar mounts touch the bulkhead.
03-27-2008, 07:51 PM
#47
I removed a little plastic from the bottom of the rear hubs or uprights where
the pivot balls connect to the lower arms to prevent binding.Also when running the short wheel base you might need to remove just a little plastic
where the front swaybar mounts touch the bulkhead.
the pivot balls connect to the lower arms to prevent binding.Also when running the short wheel base you might need to remove just a little plastic
where the front swaybar mounts touch the bulkhead.
Are you going to try running the car before the Motonica race?
03-27-2008, 08:12 PM
#50
interesting
Kinda like this car..where do we get one?
03-27-2008, 09:35 PM
#56
What about fifth sunday?
03-27-2008, 09:37 PM
#57
03-28-2008, 11:42 AM
#59
Velox build
The Velox is a very nice build. One thing of specific note is that everything for each "step" of the build is in one bag (and these match up to the Velox manual as well). If there are sub-steps, there are individual bags for those as well. Very cool!! There's no more hunting around looking for parts in different bags. That's one of those things that I've always asked myself "why don't they do this...". Fit and finish of all parts has been excellent so far.
