mx51

iTrader: (8)

I need to buy a new servo for my truggie..I was told i should buy a hitech 7950 and was wondering what you guys think...Is there any servos that are almost as good that don't cost so much? I thank you for any suggestions..

Ei8ht

iTrader: (127)

Unregulated Lipo - 7950. NiMh/LiFe/regulated lipo - Hitec 7955 is fantastic for truggy steering. 93.99 from servo city...

http://www.servocity.com/html/hs-7955tg_servo.html

even less used...

wichitafc98

iTrader: (47)

If you want to a High Voltage setup, I would use the 7950. I 7955 has a lot of torque but a bit slower than the 7950.

mx51

iTrader: (8)

Want do you mean by a unregulated lipo?

Ei8ht

iTrader: (127)

Unregulated lipo is 7.4v. Adding a lipo regulator will bring it down to 6.0v so you can use non-HV servos without burning them up.

http://www.amainhobbies.com/product_...rce/google_ext

Are you talking about Nitro or E? Are you running LiPo, LiFe, or NiMh?

Also, the 7950 is only faster if you are running it on 7.4V, if run on 6.0v its the same speed but has a bit more torque...

mx51

iTrader: (8)

I am running nitro and my reciver packs are 6.0 volt nimh..

Ei8ht

iTrader: (127)

At 6.0v, I'd go with the 7955...

mx51

iTrader: (8)

Ok thank you man..

hlpressley

iTrader: (209)

Don't forget about the Savox line. They are great servos that are just as good as any out there and are a good bit cheaper. We sell them here at the shop daily and have never had a single return. That's pretty good seeing that we have sold over 200 since Jan.

drewmugx5t

iTrader: (21)

+1, I got a 1258tg from hlpressley and it has been great running on LiFe.

mx51

iTrader: (8)

What savox would be good for a 1/8th scale truggie?

mr240

iTrader: (61)

Get the 7955. You won't be disappointed.