Hpi Pro 4
#6046
Tech Adept
Originally posted by Pit-racer
I just went thru my pro4 and rebuild it. Do you guys have trouble w/ the e-clip that goes on the spur retainer? Does it cause the spur to be off center as it spins?(wobble a bit)
I just went thru my pro4 and rebuild it. Do you guys have trouble w/ the e-clip that goes on the spur retainer? Does it cause the spur to be off center as it spins?(wobble a bit)
#6048
question
is der a pro4 hara edition?
is der a pro4 hara edition?
#6050
Tech Adept
If you have play in your spur check the position of the 3 smaller shimss and if needed put another one in.
#6052
PRP make a "TruSpin" spur gear plate which goes on the side with the screws, this should help.
Also, Square make a spur gear plate machined with the output shaft so there shouldn't be any play in that.
Also, Square make a spur gear plate machined with the output shaft so there shouldn't be any play in that.
#6053
Tech Champion
iTrader: (9)
Originally posted by Skill
PRP make a "TruSpin" spur gear plate which goes on the side with the screws, this should help.
Also, Square make a spur gear plate machined with the output shaft so there shouldn't be any play in that.
PRP make a "TruSpin" spur gear plate which goes on the side with the screws, this should help.
Also, Square make a spur gear plate machined with the output shaft so there shouldn't be any play in that.
#6054
Tech Elite
iTrader: (3)
Originally posted by Pit-racer
There is no play, it might be the 4 screws or the pin it sits on or the e-clip. I will find it Is there a plate made for both sides? to sandwich the spur evenly?
There is no play, it might be the 4 screws or the pin it sits on or the e-clip. I will find it Is there a plate made for both sides? to sandwich the spur evenly?
#6055
Originally posted by kewdawg
Are you using a Hpi spur?When I use any other spur w/ only 2 holes, for the screws(Robinson Racing or Kimbrough), I get a wobble in the spur.
Are you using a Hpi spur?When I use any other spur w/ only 2 holes, for the screws(Robinson Racing or Kimbrough), I get a wobble in the spur.
#6056
Originally posted by Pit-racer
I just went thru my pro4 and rebuild it. Do you guys have trouble w/ the e-clip that goes on the spur retainer? Does it cause the spur to be off center as it spins?(wobble a bit)
I just went thru my pro4 and rebuild it. Do you guys have trouble w/ the e-clip that goes on the spur retainer? Does it cause the spur to be off center as it spins?(wobble a bit)
Z251, SPRING PIN 1.5x8mm (10pcs) $1.50
#6057
New Part!
TR9502 Alloy input shafts now available from Titanium Racing/Schumacher
TR9502 Alloy input shafts now available from Titanium Racing/Schumacher
#6059
Originally posted by rice
question
is der a pro4 hara edition?
question
is der a pro4 hara edition?
#6060
assasin,
bro wer's the pic of ur pro4?
bro wer's the pic of ur pro4?