Putting a RX8 in my SCTE and I'm having some problems with the motor direction.
Previously when running the 1410 with the mamba I just switched the black and red wires, but figured I would follow the tekin diagram for wiring.
Would the easiest thing to do be just switch black to A and red to C?
Since the 1410 is sensorless this is cool right?
I would prefer not to have to mess with servo reversing and recalibrating etc.
Thanks in advance.

ttt

Swapping any two wires will reverse the direction on a sensorless motor

Cheers

thanks for confirming, just makin sure I dont pull a bone headed move.