Alex Racing Barracuda R2 & R3
Tech Regular
Hi Dave,
Your servo saver as in http://www.rctech.net/forum/attachme...&postid=946804.
Kindly advise what make it is and from where we can order one!
Thanks a lot!
Mark from MALTA
Your servo saver as in http://www.rctech.net/forum/attachme...&postid=946804.
Kindly advise what make it is and from where we can order one!
Thanks a lot!
Mark from MALTA
Re: No news .//
Originally posted by JDM_DOHC_SiR
little slow today guys...
-Dave
little slow today guys...
-Dave
Tech Champion
iTrader: (31)
Re: Re: No news .//
Originally posted by Herminator
you talking about your racing again?
you talking about your racing again?
-Dave
BTW hows that f1 HOLDING UP!
Tech Champion
iTrader: (31)
Originally posted by dhiracing.com
Hi Dave,
Your servo saver as in http://www.rctech.net/forum/attachme...&postid=946804.
Kindly advise what make it is and from where we can order one!
Thanks a lot!
Mark from MALTA
Hi Dave,
Your servo saver as in http://www.rctech.net/forum/attachme...&postid=946804.
Kindly advise what make it is and from where we can order one!
Thanks a lot!
Mark from MALTA
-Dave
Re: Re: Re: No news .//
Originally posted by JDM_DOHC_SiR
.. My dear Petey... yo can come to Japan any day if you need a lesson
-Dave
BTW hows that f1 HOLDING UP!
.. My dear Petey... yo can come to Japan any day if you need a lesson
-Dave
BTW hows that f1 HOLDING UP!
The F1 is great, a very useful paperweight for the gearchart in my pit box
Tech Champion
iTrader: (31)
Re: Re: Re: Re: No news .//
Originally posted by Herminator
The F1 is great, a very useful paperweight for the gearchart in my pit box
The F1 is great, a very useful paperweight for the gearchart in my pit box
I knew you would find a use for it
-Dave
Tech Champion
iTrader: (31)
Back to the R1
I decided to break out the R1 and use it untill the R3 gets done...
Here is a few pic`s
-Dave
Here is a few pic`s
-Dave
Tech Champion
iTrader: (31)
..one more
..
Tech Champion
iTrader: (31)
..more
.
Tech Champion
iTrader: (31)
front shot
.,
Tech Champion
iTrader: (31)
rear shot
..
Tech Champion
iTrader: (31)
One more new paint job
front grill
Tech Champion
iTrader: (31)
Re: One more new paint job
Side rear
Tech Champion
iTrader: (31)
Re: Re: One more new paint job
Full shot
Tech Champion
iTrader: (31)
Modifed R3 bulk heads
Hey guys here is what most of the ALEX Japan guys are doing to there Bulkheads on the R3`s(will work with the R1/R2 also) They are doing this to get a longer upper tie rod when using the Pal hubs...Alsoon a little side not ..I have been testing out a alternative to the Pal hubs and I have found out that you can use the TC3 front c-hubs and .. I am also sure that the Pro4 rear hub will work with a little modification to the hinge pin hole..(opening it up to 3.05mm)..
-Dave
Bulk head pic
-Dave
Bulk head pic