mrblond03

Is there a mod required for the hudy set up to work with the S710, i remember a post somewhare but cant seem to find it.
Thanks

jfc_tech

iTrader: (4)

my friend, try serpent 710 thread.

InitialD

Page 179 of the Serpent 710 thread by Fernando_M. I don't know if it's in the FAQ compiled by markp27 but you can also see the mod here.

mrblond03

Thanks thats the one, I had got to page 104 (is there a way to index long threads?) to make finding things easy

Pyramid

If possible, just get the new one. Hudy has made running change to its HSP-108250 ultimate setup which works perfectly for S710

mop_iko

you actually can change the URL of the page number u want to go...

ok i post the URL here:

http://www.rctech.net/forum/showthre...pagenumber=179

.. i have one question...

coincidently i just bought the HUDY setup board today.... i dont know the part number though... whether the setup board is the right one for 710 or not.

IF i bought the setup board that is compatible with 710... can i use for my NTC3 also? this is my first time holding a setup board... actually i dont know how it work yet!


mop

mrblond03

There is an apendix sheet in my box for the NTC3 a little Dremmeling is required for that car, (but no mention of the 710)

im under the impression my set up from Hudy is a new one as they have been out of stock for a couple of months and mine arrived yesterday.

thanks for the info on the page url, but still unless you know the page its a long haul to go through (although informative and at times funny)

mop_iko

just opened the box and setup the board.

after reading briefly the discussion about the hudy setup board changes for 710. this is what i found.... if you are using or accidently bought an old version of hudy setup board... u just need to dremel a hole for the rear wheel stand just allowing u to access the screw.

aaaaaaaaaaarghhh difficult to explain. just take a look at the pic.

mop

Pyramid

I believe you could simply judge (for those who haven`t purchase one before) the new one by looking at its support block.. If it is hollow, then you got the new set.

mop_iko

ok.. just remembered to post this question:

i tried to use myu HUDY SETUP BOARD.

my question :

when u do the cambering and 'toe'ing out for your front wheels... do you TURN ON your TX and RX?


mop

Solara

iTrader: (17)

It won't hurt for sure.....but usually (for me) I don't turn on radio while I am setting up cars in the middle of the race (Control RADIO use period).....but at home, you can do that....especially when you are adjusting the TOE on steering.........

It is a peace of mine thing.............