Hello. I recently purchased the aggresor crx and it came with a nicd radio pack and a wall charger with both rx and tx charging leads. I noticed Hitec is releasing a nimh radio pack and I was thinking about getting it. My question is: will I still be able to use the wall charger that came with the radio to charge the nimh pack? And if so, does that mean I will be able to charge my nimh receiver packs with this same wall charger? And if I can't use the same wall charger for the nimh pack then which Hitec charger should I buy to use with the new nimh pack. Thanks.

The wall charger is NOT a peak type charger, it will charge the NiMH packs but can not tell when they have peaked.
Plus it charges at much lower rate.

You can charge AA's between .75 & 1 AMP with no problem.

Either the CG-335 Pro or CG-340.

I use the CG-335, it is a VERy versitile charger.



Applications: 4-24 cell 270-3000 mAh NiCd and Ni-MHbattery Packs
Input Voltage: 9 -13.8 volts DC
Min Input Amps: 10A min (10A needed for full functions)
Charge Rate:
Primary Port

NiCd 4-24 cells 0.5 - 5.5Amp

Secondary Port

NiCd 4 cell (4.8v) 250 mAh fixed


Glow Port

Single Cell 1.2v 1.1A

LCD Display
DC-DC Charging w/boost circuit
Delta Peak W/auto trickle
Delta Peak Cutoff(Primary and Glow ports only)
Initial Cut Off Error Override
Input/Output Polarity Protection

Cool! thanks. Now I'm just waiting for that pack to be in stock somewhere!