-Done!


-New shoes!


-Balanced!

All bearings cleaned and greased...


-After all they neede some care!








-Checking main spur and the pads, as cleaning and greasing her bearings!


-Front diff, now!


-That was good, just clean and grease the bearings and put a couple more of shims"


-600 and 800 sand paper on the plates.


-Closed!








-New suite and new shoes. Ready for play!

Nice car, I like the the paint on it. I picked up a b44.1 to have some fun with this summer, looking forward to it.

I like the paint to!

Made a video....

+ YouTube Video

Nice video. Looks like a great place to ride a bike!

Any advice for b44.1 gearing with 6.5, 7.5, and 8.5 motors?

same as a .2 or .3 you can look a AE site for any gearing options
6.5 17-18/81
7.5 19-21/81

Thanks. I downloaded the .1 manual and didn't see the gearing recommendations in there like most ae manuals. I'll look again, and check out the .2/.3 manual as well.

I traded my Speed Passion motor for another RC..so i needed a new motor for this one...


-Monsters & Scorpions!! :P







-Needs soldering and install!!

Allright! Hand on job!! :P


-Soldering done!


-Anti vibration gel for ESC from Kyosho :P


-Let's see what this can do!!


-Hard speed runs till LVC kicks in...12minutes. After that the motor is still fresh!!


-It goes to 58kmh on 23T pinion. I can gear higher cause motor is not even warm at the end of pack! Last motor was with 19T pinion and was hot at 6 minutes!! :P But shows 65kmh




-The settings i use right now on 23T pinion...

Well, Scorpion to the name! Freshness with tall gearing? :P

Went to the LED bug...







With a "gizmo" remote switch i can on/off the leds on the radio. I need to make a video :P

+ YouTube Video

Can you run gear diffs in the 44.2?

Still competing in the Dirt.