running it sensorless is indeed dog slow.

Sensor cable fell out the weekend and lap time went from 16s to 43s :P bad times.

Anyone ?

Yes you can i just did
works great

If your 3T is indeed a sensorless motor....I really think it is a waste of time when you are running a sensored base speedo with a sensorless motor and with the sensored base software...

You can try, but I doubt it is any good...

If you talk to ERIC @ Harbor Hobbies, he will get you the Speed Passion version of LCD box.

Or Brian Jucha @ Strictly....support your local hobby shop.

PM me with your question, I will be running the support of SP thru out the Asphalt Assault series and at Harbor, Al's. LHR and Strictly location.

Are there any ideas on what option 11 will be on the programmer? I thought it would of been the start rpm.

start rpm already has a number

Hi All,

Does anyone know if the GT 2.1 can run in modified if you just upload it with Firmware say 205...and scrap the stock software..

Have been told its the same internals....and with the casing being aluminium should run cooler....

Thanks

Steven

can use hobbywing LCD program card !

The 2.1 can run mod. I think it is down to a 5.5 and yes on the FW205.

K, so what about ending? LOL

END RPM = Boost Start RPM + (Boost Timing + Turbo Timing) * Timing Punch

From HW manual but applies here.

Only a 5.5? So its like A LPF.

Hmm thats too bad, wont be able to compete with that at the BRCA Nats

Was hoping to run a 3.5 on it.

It IS labeled as 2.1 PROSTOCK...

why do you need a end rpm, is there an rpm where you want the supercharger to turn off?? I want it to pull until "I" decide to let go of the trigger