It happened to me when I was running the timming at 4/11.25 deg.

It was impressive though just felt it could do with more punch on the bottom end (low RPM ) and more track time.

For the offroad guys this is what I ran with.
10.5 speedpassion version 2

1-1
2-2
3-4
4-8
5-3
6-4
7-1
8-1
9-4
10-1
11-1
12-9
13-4
14-6
15-6

Gearing 23/76 2.6 to1 gearbox, temps motor and speedy around the 60 deg celcius. 30 deg ambient temp

il be there bright and early with bells on around 7 to get a good spot

Just ordered the LCD Box. Cant wait to test the new software on my GT Pro esc.

anyone have advise for 13.5t running on small and technical track ??
Size around 120ft x65ft

Thanks

Lower supercharger level and lower AMTS, with higher DRRS and supercharger punch.

GT2 Pro also can use super charge? with one better GT2pro with supercharge or GT2.1 stock to run stock motor ?

Yes it can - I'm running GT2 Pro with new firmware.

Hello,
This should be the last update. Some setup has been fixed with the correct name.

Have fun.

Download Link: http://www.megaupload.com/?d=CTJQ3TLY

Ringraziarla il mio amico.

Here is what Adam's getting this weekend.

Yeh, I dropped this to 6 for some more smoothness, but the car was like a snail! and barely hit half throttle - i tried resetting the end points and re-calibrating, but nothing. So I just put it back up to 7 and left it at that.

Hello,

my Name is Oliver and i come from Germany. I drive a Xray T3 with Rubber Tires. I have Questions but my English is not so good.

I had load the new Beta Software with 231 but i donīt have drive with them. I tested on my table :-)

The RPM is very high on AMTS Timing 8, but i can not understand on #15 is 6 value but on the setup sheet it goes from:

Motor Hot Max
-1
-2
-3
-4
-5
-6
-7
Motor Cool Max

there are 9???

Is there a driver they had tested the Software with a Touring Car? with a 17,5 and a 13,5 Stock Engine?

What is the different about 230 and 231?

Olli

Has been fixed the setup #15...i was following a previous guide where the max value was 9..and it was wrong

Well, at the moment there are only 6 values that you can choose.
I tried it with 13.5T v3 SP motor in TC.

230 is more agressive than 231 and produces slightly more power but I belive you'll have to keep an eye on temps more.

Hi

Just a quick question - probably more aimed at Shaun/Adam but if anyone else knows the answer that would be great

I'm at a race meeting this weekend, but along with actually running the meeting I'll be fairly limited on time to work on my car! I was thinking of trying the new software, but I won't have (another!) laptop to use to re-program my speedo.

What I basically want to know is, if I install software 230 onto the speedo but don't get the time to play properly with it and get it adjusted to my liking, can I then put Setting 12 (Boost Level) to "1" (Off) - will this then effectivly disable settings 13, 14 and 15 and act in the same way as if I was running software 107??

Many thanks for any advice
Oli

Is it a day race? I thought it was a night race

Yeah by putting the setting to zero you wont be running it, so yeah in theory yes