SlowerOne

Or the new addition on height we can cut out on the rear? Realise you're busy Scotty, but these things are needed soon - Jamie is older and wiser now, so if we don't get it right he'll catch us!!

syndr0me

iTrader: (32)

Guys, will there be any rules against heat sinks/fans on spec motors? For example, the Novak heatsink that replaces the center ring on their motors. And will it be treated differently between, say, 13.5 and 17.5 amateur? Thanks!

Edit: I ask because I think it was disallowed last year when the motor was a handout, and I think certain organizations (like BRL) have rules against cooling.

voodoochild

this looks like the worst day ever to me!!!!
Charlie I still have a ace in my back pocket....

walterhenderson

And I thought it was your birthday!!!

Charlie

Oh, wait, I just thought of another rule.......


If I can't remember it..... It didn't happen........


Everyone knows you're a photo shop wizard so any pictures you have of me are probably fake............. and here, I'll ruin your ace with my joker..... It's a picture me yacking in a parking lot....... like falling into it yacking...... You forget Tennies..... Charlie Has No Shame! Stupid Patron..... Stupid Stupid Patron.......


Can't want to see you little buddy! Since you're so able to post pics why don't you answer a question or two..... I so almost deleted this......... but well, it's two thirty in the morning, and I just got done installing 15 LED's on my RC Rock Crawler so at this point I'm a bit punchy.......

wow, I can feel the look SE is giving this post...... Sorry I missed your call tonight buddy, by the time I got back to my phone it was like 4AM WI Time. I'll be around all day tomorrow though.

voodoochild

World GT Body
1) Maximum Width 205mm
2) Minimum Roof Height (Ready to Run) 104mm
3) Wing Max Width 200mm
4) Wing Max Chord 45mm
5) Wing Max Side Dam 45mm x 20mm
6) Wing must be fastened to the rear deck of the body
7) Rear Wing may not be higher than roof height
8) The rear of the body must be trimmed no more than 40mm higher than the ground level with the body mounted.

The Bear

iTrader: (13)

I don't understand.

Was Charlie 'giving' or 'getting' his birthday present there?



@
=
=
=
00

Charlie

Atta Boy Tennies!

SlowerOne

Thanks Jamie!

kn7671

iTrader: (16)

Regarding the motor rules, will 12.5mm rotors be legal if the stock rotor is 12.3mm?

voodoochild

PM sent

The Bear

iTrader: (13)

Helpful information?

- Don't pay for a massage you have to sit back to back with a buddy for. Especially in Vegas.

- The trash cans (yes, even those next to the xray pits) are not for poo'ing in

- Careless charging of a lipo is like unprotected sex. Charging doesn't last as long and sometimes results in an unwanted explosion.

- A car glued under a table is only funny when it isn't yours

- Having to adapt to rule changes makes it more fair for everyone.

- enjoy racing toy cars in FREAKIN' Vegas!!!!!!!

HB Moose

Just wondering why this is a Private message issue and not being discuss in the open forum.

Ericjooopuntnl

What bodies did last years competitors drive and went well in stock rubber???

Thanks,

Eric

artwork

iTrader: (88)

Mazda speed 6 and Mazda 6 bodies, but I bet you will see a few LTC-R's this time around.