Tonight I tried setting up my new car. I installed the new reciever as stated by the instructions. Powered the transmitter up first then held down the button on the Reciever. Powered the ESC up and let go after 2-3 seconds. Then hit the bind button the on Transmitter. The reciever blinks as said it will but never will light up blue. Never have any control of the servo or speedo.

Any suggestions? Send back to factory?

Thanks in advance for the help.

press the enter key on transmitter right after receiver light begins to blink.
Light only flash`s 4 or 5 times, if your late ? Start again

Found my problem out. Evidently I purchased the wrong reciever. I have a 2.4ghz for an M11 instead of the MX3 I have. However I have purchased an M11, so I'll try it with that transmitter. Sorry to bother everyone. But I thought I'd at least post to make people aware that they may have problems if they buy the wrong reviecer.