LowBoost

iTrader: (63)

Uriah:

Are there any pre-orders (RBM3)? I have been trying to contact Murnan Mods for 3 weeks. Even PMd you.

grub

ive asked the same questions
i know hes been away
im in da dark too
and im running out of time

Grinder

iTrader: (2)

Yes, we have been taking pre-orders for a week now. PM sent.

Grinder

iTrader: (2)

Please check out the website. We have been taking pre orders. We have a special pre-order price for the next week.

grub

thanks grinder

GMartinez

iTrader: (91)

Uriah that RB you ran in the mains was sick blowing by 2 guys on the stright was priceless see ya @ the Nat's

Ultraspeed84

iTrader: (45)

how much fuel can one get in the .12 motors? how many gallons will they last before they die?

grub

i have one of murnan's nova 12-3plu sct
been running it over 12 months and is still fast
had 8 plus gallons of fuel through it
look after the conrods and you keep the engine well over 12 months

Ultraspeed84

iTrader: (45)

What run time u guys getting with the RBm3? also what pipe u been running with it?

KWT-NITRO

iTrader: (9)

Hi Uriah,

how are you, hey am about to order a novarossi .21 plus 4 from the site but would like to know what pipe goes the best with it? for an overall power band, more run time and a bit more power in the low-end range.

cheers

Ali

Grinder

iTrader: (2)

Hi. I like the Novarossi 9901. Plenty of power, and long runtimes. Try the Novarossi 9886 for more power, at the cost of some runtime.

Grinder

iTrader: (2)

That really depends.. a lot. Here in the US on the more fuel thirsty tracks I can get at least 5:30 seconds on the engine with 16% nitro. Some of my other drivers who have a smoother throttle finger are getting over 6 minutes on a tank. My European team drivers are getting upwards of 7 minutes. I guess it all depends on the conditions like, track conditions, atmosphere, clutch, etc...

I like to use the Novarossi 2601, or 2630. I like the 2601 with the short header most of the time, and the medium header with the 2630. The 2630 can make the engine faster than the 2601, but you will lose about 15 seconds of runtime with the 2630.

I can say when tuned properly the engine gets great runtime compared to most engines with less power.

KyoshokiddT.D

more power than most can honistly handle big tom

Grenade10

iTrader: (40)

Grinder ... Received the 35+21 early this week!

What header and pipe would you recomend for this. will be using at Toledo in September!!

Thanks
Mark W.

Nitro-Racer*

hey uriah have you tryied the novarossi 2652 or the 3501 tuned pipes with the rbm3 and if so what are the ups and downs??