Can you take out the low speed needle housing on my V-Spec.

http://www.amainhobbies.com/product_...ducts_id/16833

this part is the part I was going to take out.

Probably if they sell the part seperate, just be easy with the soft metal.

Parts are all removable..you'll be fine

Remove the idle screw & slide should come out.Just be carefull when putting the rod end collor back on.You can deform the slide,strip the collor or set screw if you tighten too much & guess what happens if not tightened enough.

thanks for your help. guys I will give it a shot.