Tamiya mini cooper
#7052
Yes. The rules for this year's mini class at the TCS Nationals in Aliso Veijo are:
1200 grams minimum weight
2400 Orion Lipo batteries.
Motors will be silver can hand out and you have to leave the motors in tech. You cannot take your hand out motor back to your pits!! You go to tech before your heat, put your motor in your car and run your race. After you race, your car goes into impound and after you turn marshall, you go to impound, remove your motor and give it to tech to hold until you next race. We might have to use plugs as well!!!
1200 grams minimum weight
2400 Orion Lipo batteries.
Motors will be silver can hand out and you have to leave the motors in tech. You cannot take your hand out motor back to your pits!! You go to tech before your heat, put your motor in your car and run your race. After you race, your car goes into impound and after you turn marshall, you go to impound, remove your motor and give it to tech to hold until you next race. We might have to use plugs as well!!!
#7053
Tech Fanatic
The Tamiya TCS organizers are really trying to get the Mini class back to a driver’s class so they are going to have RPM limits on the hand out motors (the RPM maximum being discussed is 14,000). They will test your motor when you take it out of your car and turn it in. If it goes above 14K at 5 volts, then penalties could be handed out. It has not been announced how they will dish out the punishment. The challenge is going to be how to keep your motor from going over that 14K. After you run one of these silver cans, the brushes break in, the bushings break in and the heat will drain the magnets, all causing a motor to increase in RPM.
It's going to be a hoot!!! I can't wait.
#7054
Tech Elite
iTrader: (26)
The Tamiya TCS organizers are really trying to get the Mini class back to a driver’s class so they are going to have RPM limits on the hand out motors (the RPM maximum being discussed is 14,000). They will test your motor when you take it out of your car and turn it in. If it goes above 14K at 5 volts, then penalties could be handed out.
#7055
Tech Lord
iTrader: (26)
Yes you will need to add weight to get to the new 1200 gram minimum if you are using the Orion 2400 lipo. Not sure if the batteries have to remain in tech but probably not as how would you charge them?
The Tamiya TCS organizers are really trying to get the Mini class back to a driver’s class so they are going to have RPM limits on the hand out motors (the RPM maximum being discussed is 14,000). They will test your motor when you take it out of your car and turn it in. If it goes above 14K at 5 volts, then penalties could be handed out. It has not been announced how they will dish out the punishment. The challenge is going to be how to keep your motor from going over that 14K. After you run one of these silver cans, the brushes break in, the bushings break in and the heat will drain the magnets, all causing a motor to increase in RPM.
It's going to be a hoot!!! I can't wait.
The Tamiya TCS organizers are really trying to get the Mini class back to a driver’s class so they are going to have RPM limits on the hand out motors (the RPM maximum being discussed is 14,000). They will test your motor when you take it out of your car and turn it in. If it goes above 14K at 5 volts, then penalties could be handed out. It has not been announced how they will dish out the punishment. The challenge is going to be how to keep your motor from going over that 14K. After you run one of these silver cans, the brushes break in, the bushings break in and the heat will drain the magnets, all causing a motor to increase in RPM.
It's going to be a hoot!!! I can't wait.
I find all of that very, very interesting. We started a mini class here this spring and with loose enforcement it took about 4 races for it to not really be a "driver's class" anymore. We're also trying out a couple other spec silver can classes so I'll be watching how the new TCS system works out closely.
#7058
Tech Champion
iTrader: (110)
We've been running minis with Lipos (Orion 3200s) for nearly 2 years now. And until the TCS season came along we only ran 2 oz. of lead on the underside (wings) of the battery. I believe the cars are around 1240-1250 grams and handle superb. So don't let anybody tell you the car has to weigh as much as a NIMH car to handle well and not flip....a little tip...CA is your friend.
#7059
Tech Elite
#7060
This is basically a RWD chassis I built by myself with a Tamiya Cooper S body.
It has Yokomo drift red wheels with Touring Type As all around
[img][/img][/url]
[img][/img]
The chassis I built.
[img][/img]
[img][/img]
[img][/img]
Rear suspension:Single stock shock mounted to steel stand(T-bar)
Front suspension:N/A(Still thinking)
Chassis:Hard poly enamel
Wheelsand Tires: Yokomo advan RED WHEELS with Touring Type As
Gear ratio:11:1
Drive:RWD
I used touring tires because of the high gear ratio I had.It also gives the car stability over bumps.
Mini Cooper...with big wheels. Cool ?
It has Yokomo drift red wheels with Touring Type As all around
[img][/img][/url]
[img][/img]
The chassis I built.
[img][/img]
[img][/img]
[img][/img]
Rear suspension:Single stock shock mounted to steel stand(T-bar)
Front suspension:N/A(Still thinking)
Chassis:Hard poly enamel
Wheelsand Tires: Yokomo advan RED WHEELS with Touring Type As
Gear ratio:11:1
Drive:RWD
I used touring tires because of the high gear ratio I had.It also gives the car stability over bumps.
Mini Cooper...with big wheels. Cool ?
#7062
RP MINI Tire next week come back !
#7063
Tech Elite
iTrader: (7)
Join Date: Jun 2002
Location: Melbourne, Australia. Home of rc-mini.net
Posts: 3,549
Trader Rating: 7 (100%+)
Sick of those 'Lipo Blues'? That feeling you get when your Mini keeps tipping over or spinning out with your brand new Lipos fitted? Plus you just don't know where to put the weight to bring your car up to the minimum weight your track requires?
Click here to find out how/where to to do a 30 minute makeover on your mini to add a little poundage and take a whole lotta worries off your mind.