Bang 4 the Buck....?
08-27-2007 | 09:26 PM
#1
Thread Starter
Tech Initiate
Joined: Aug 2007
Posts: 23
Bang 4 the Buck....?
Can you recommend a a vendor to modify my .32 ?
I spoke with TNT and he sounded knowledgeable but maybe a little too laid back, i don't know.
I've heard of RBMods as well, most of these guys charge around a $100 for their work and that is more cost effective than me buying all the tools which would total well over $100 plus my time and limited knowledge, i don't want to screw it up so who wants to port it for me, any takers that the board can recommend?
I don't need the best, just good-quality work, Thanx
I spoke with TNT and he sounded knowledgeable but maybe a little too laid back, i don't know.
I've heard of RBMods as well, most of these guys charge around a $100 for their work and that is more cost effective than me buying all the tools which would total well over $100 plus my time and limited knowledge, i don't want to screw it up so who wants to port it for me, any takers that the board can recommend?
I don't need the best, just good-quality work, Thanx
08-29-2007 | 03:22 PM
#2
Tech Rookie
Joined: Aug 2007
Posts: 10
From: Charlotte, NC
I have had two motors done by RBMods and have never had a problem with either. Everything that I have seen come out of his shop is quality.
www.rcglowplugs.com
www.rcglowplugs.com
08-29-2007 | 06:57 PM
#3
call Adam @ AB Mods. Talking to modders is the best way to find out who you want to mod your engine.
502-751-3805
examples here.
www.abmods.com
Ive also seen he has a X-Dyno in his toolbox.
502-751-3805
examples here.
www.abmods.com
Ive also seen he has a X-Dyno in his toolbox.
Last edited by German Muscle; 08-30-2007 at 12:15 AM.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
