TC3 Forum
#4816
Originally posted by highwayman
NTC3NUT
what was the modifications you had done to your steering and/or shock tower?
also, have you ever experienced in your NTC3, the front and rear shock towers keep on loosening from the bulk head (diff case)... if so, what do you do to remedy this...
thnx...
NTC3NUT
what was the modifications you had done to your steering and/or shock tower?
also, have you ever experienced in your NTC3, the front and rear shock towers keep on loosening from the bulk head (diff case)... if so, what do you do to remedy this...
thnx...
And the NTC3 shock tower coming loose, common problem. The least you should do is install longer 4/40 screws in the center hole, and the hole on the ring gear side. And use thread locker or CA. If you want to go heavy duty buy "The Fix" and a set of aluminum diff cases.
#4819
#4820
NTC3NUT:
i didn't know that there were aluminum diff cases for the NTC3, can you tell me where i can buy them?
i used longer screws on 2 of the 3 holes of the shock tower, but i didn't put c/a in them, will try it out next time around...
What's " the fix "
thnx...
i didn't know that there were aluminum diff cases for the NTC3, can you tell me where i can buy them?
i used longer screws on 2 of the 3 holes of the shock tower, but i didn't put c/a in them, will try it out next time around...
What's " the fix "
thnx...
#4822
Tech Initiate
Joined: Nov 2002
Posts: 21
From: davao
I installed the green springs in the front to allow more weight transfer to the front hoping that it would eliminate the push. I don't have any problem at turn in, my problem is when I start to apply throttle, the car pushes to the outside of the turn instead of taking the turn.
#4824
Originally posted by highwayman
NTC3NUT:
i didn't know that there were aluminum diff cases for the NTC3, can you tell me where i can buy them?
i used longer screws on 2 of the 3 holes of the shock tower, but i didn't put c/a in them, will try it out next time around...
What's " the fix "
thnx...
NTC3NUT:
i didn't know that there were aluminum diff cases for the NTC3, can you tell me where i can buy them?
i used longer screws on 2 of the 3 holes of the shock tower, but i didn't put c/a in them, will try it out next time around...
What's " the fix "
thnx...
#4825
Originally posted by jta
I installed the green springs in the front to allow more weight transfer to the front hoping that it would eliminate the push. I don't have any problem at turn in, my problem is when I start to apply throttle, the car pushes to the outside of the turn instead of taking the turn.
I installed the green springs in the front to allow more weight transfer to the front hoping that it would eliminate the push. I don't have any problem at turn in, my problem is when I start to apply throttle, the car pushes to the outside of the turn instead of taking the turn.
also, increase front droop
Last edited by theisgroup; 04-19-2003 at 05:28 AM.
#4826
try rdlogics web site they have alloy diff cases for 20 a piece ....silver or blue ...
www.rdlogics.com
www.rdlogics.com
#4830
Joined: Sep 2001
Posts: 2,152
From: Newville,Pa
Maybe they are learning from past mistakes..... Associated is well known for setting on their heals and waiting too long to release new cars, normally by the time they do the old one is so outdated they almost have to rewrite the book!!!!



65Likes