First off let me thank the staff here at R-C Tech for providing us with this space. My name is Jason, I'm the on-line support guy for MaxAmps.com. I work here and at several other on-line forums around the net. My purpose is to help any of you out with any questions that you may have concerning the products that we sell at MaxAmps.com.

So if any of you have questions...just fire away I check in at all of my sites several times daily to keep on top of things and to get you the answers you need in a quicker fashion.

Here's the web site www.MaxAmps.com
our toll free number 888-654-4450
and my e-mail addy [email protected]

enjoy......

Jason Melville
MaxAmps Crew Member

I'd like to say that I like your batteries. I own 2 6000 MAH packs and they Work great.
I've been running off road with a XXX-T Losi truck.
I have been running against 1/10 gas trucks and running 20 minute mains.
I'll add that I have a potential of running 30 minutes I believe.?

And I have been winning with a Novak GTB, sintered rotor 4300 motor. The speeds are pretty close.

Now my QUESTION is who manufactures your packs.

And are there any charging speck sheets.

Thanks, and thanks for opening up for questions. Theres so much hype about quality cells that it can give a head ache.
The max Amps so far seem to be just as great a quality as any other.?

UN4RACING, I'm glad to hear you like our packs.......as for who makes them........well we do...in house....It's by far the best solution.....you order your pack, the order goes to production..........they make your pack with matched cells only and the connector and tap of your choice. It's win win and super fresh packs are out to you in little as 24 hours.

As for charts there are some posted over at RC Groups in the Batteries and Chargers section. But I'm not sure if they list the new copper tab cells.

The rest is all factory secrets that I don't know nor do I want to.

Jason

Mostly i was Interesting on LiPoly battery,
i have seen your Poly has 12000mah
Where i can buy at My Country in Indonesia , Jakarta?

Simply send [email protected] and email and he will let you know if we can ship to you.

Is there any way to get some max amp stickers.?

i have a maxampas 6000 7.4 volt battery that ballooned up on me when i was running it in my e-revo. my question is how do i discharge it properly so that it doesnt explode?

How does the IR and average voltage compare to say the Kokams?

Thanks,

jrr102486, you can drain them by hooking up to a 12 volt car bulb.........sset it outside away from anything and let the bulb drain it down to zero.

Crash you need to be more specific which pack of ours do you want to compare with which pack from kokam. I will tell you from the start ours are cheaper and we offer the 3yr/300 cycle warranty not to mention top notch customer service if a problem should arise.

Jason
MaxAmps Crew member
[email protected]
www.maxamps.com

then can i just put it in my local hobby shop battery disposal then? what about using salt water, ive heard that that works also but im not sure.

thanx

Kokam aka Orion 4800 vs Max Amps 2S 5000HV.

Thanks,

awesome batteries and great prices. however i do have a few questions. 1) i'm charging with a ice charger at 6 amp, when charging, the amprege starts dropping at about 3000 miah or so. (these are brand new packs from you) (1st charge)then the amps start dropping off. clean down to .75, .35, .19. does that mean the battery is reaching it's peak? and is there a avreage time it takes to charge a 6000 2 cell? i charged one last night at 5 amps with your balancer and at 69 minutes it was only at3400 miah, the charge amps was dropping off, it was clean down to.24amps i believe. shut charger off. it was reaching 2 in the morning. 2) i'm running a novak 4.5r non lipo speedo system and novak low voltage cutoff. my problem is with the cut off hooked up and programed the car stutters acts all kinds of crazy but if i remove the novak cut off unit the car acts completely normal. does the novak and maxamps lipos not get along? 3) will i damage these packs if i do not charge with the balancer? and final question is does anyone make a charger with a balancer made in it?

Guys lets do this..........there are to many questions in this one thread. Would each of you please post your questions in a new thread, this way we can all keep track of what is what.

Jason
MaxAmps Crew Member
[email protected]
www.maxamps.com