Yeah i know, "Not another stupid question???" yes, another stupid question. Rollout, how do i work it out?? i know my internal and final drive ratios, now how do i get my Rollout?? Any help would be greatly appreciated....
Cheers,
Al.

Ok if you have your final drive ratio then all you need to do is do this.

Tire Dia x Pi (3.1416) / Final drive Ration = Rollout.

Eg
Spur 72
Pinion 24
IR 2.56
Tire dia 63

72/24x2.56 = 7.68
63x3.1416/7.68 = 25.77

Simple hey.




Coxy.

ROLL OUT THE BARRELL (IN A DRUNKEN SLUR)

Oldfart you always have that drunken slur

besercoe... 1/8th? how did u go?

Well the 1/8th, i definately have forgotten how to setup and drive an offroad car, although i still did pretty well, i finished 12th out of 59 drivers, missing out on the final by 30 seconds over a 30 minute race so i am pretty happy with the efforts, the new RB engine was awesome souding like an F1 car as it hurtles towards the corner just before you jump on the anchors and it nearly flips on its nose. seems like 12th place is my new lucky vic finishing spot.

Geeza was a missile and took TQ although the thuder tiger couldnt make it through to the last two minutes of the race, after being a very close second and gaining fast, would have been a win had it not been for a lost servo saver screw that had been locktited. Geeza time to break out the mig welder.

The hour long final was awesome, these 3.5 kg beasts tearing away at the track for an hour the start with ten two horsepower plus monsters launching at once is a great sight.

Your car seemed to be going good on Saturday, unfortunately I couldn't attend Sunday's racing. So when were the finals held, they were talking about racing them on Monday when I left. So what was it like going from 8-9 second laps one weekend to 40+laps the next weekend.