Your droop is entirely wrong - That droop screw should not be driven in that far.
Also you should set up travel with shocks disconnected to get the most accurate setting.

Nevermind.

The shocks were not connected when I set it the Volker way. I understand that it shouldn't be screwed in that much. That's why I'm asking how you are setting the uptravel.

Youre using the wrong screw then for uptravel.

The second picture showing the grub screw jacked all the way down is for droop.
Up travel is set by the grub screws in the front upper bumper brace and rear body posts.

Blue circle is droop screw
Red to the front is up travel

Thanks, I appreciate everyone's response to my post

Do you have the gear diff install correctly. The belt pulley should be on left, drivers side of car.

Good info. I definitely got that part right.

Anyone tested a carbon chassis yet ? How does it feel on low and high traction ?

Hey guys, I'm currently building my MTC3 and I'm going to be running it on low grip asphalt. Does anyone know any shops in the states that has either 1.6 carbon or fiberglass top decks in stock?

I found them from Vigor at a shop is AUS but they won't ship to the states.

Thanks.

Smokem rc in AUS ships to the US , I just got an order from them last week for my mtc3 .


vigor parts .

I ordered mine straight from the Vigor Rc site in Hong Kong. Came in 2 weeks.

Interesting, when I tried to check out with them it said they don't deliver to my country.

I'm just concerned will all this tariff nonsense of something not getting delivered.

I got the vigor c/f chassis for the mtc3 and a few other vigor parts .

Australia Post temporarily suspended all shipments to the US because of the tariffs, they didn't have the infrastructure in place to collect tariffs for low value (<$800) packages. They should have resumed as of yesterday though, so try pinging Smokem to ask about the situation.