I use the same setup. No change at all.

Volker is working on a new car ??? Should be excellent!!!!

what ...tell me

Will probably be a front wheel drive touring car

The BD8 is an extremely popular car and we've decide to put some attention to this model.
We've done a lot of job in the front area, as we were focused in scrub and drag reduction while turning.
For this reason, the Fenix chassis is having a special set of proprietary battery holder.

On the upper deck, extra pinion clearance is provided for those who run with high wind motors.

I need that, where can I get this in the US or Canada ???

I'd contact CRC and see when they are getting them in stock.

Does that Fenix chassis and top deck work with the Pitch Control System (PCS)?

It doesn't for you John lol

On other hand, you might notice that we choose a countesunk hole for the grubscrew on the motor mount.
By doing so, we got 2 results.
You can to put a screw there and lock the chassis torsion in the rear end, and the screw will not touch the belt.

On other hand, you're sure that the grubscrew will not interfere with the chassis torsion

Hello! Were you gluing the sidewalls (fronts/rears)? If so, how much? Thank you in advance for your reply!

I messaged CRC on FB and they have not ordered these chassis at this point yet. No info on when they expect them.

Should be shipped to them tomorrow

Yes, I was gluing the fronts only all the way before the radius.

Thank you for the quick reply! Much appreciated.