oh that's your youtube page i'm subscribed to

Ordered a TQ booster from their site this week. Anyone know where they're located?

Left a message at the phone number listed. Inquired via email to their paypal account address. Email bounced with an email address in Spain.???

Just want to get my 12 sorted... lol

If I'm not mistaking they're in Canada

canada...check your email you'll probably get an email for shipping cost. i didnt know that and it held mine up a few extra days. right after i paid it it was in the mail like 2 days later

Has anyone used the Hobbywing 1s booster???? I picked one up to use on my stock spec v3.1 100amp.

Thanks. Still no contact from them though...

Does anyone know what "ends" are being used on the side tubes on rick hohwart's car? Kevin also uses them.Link to pic below couldn't fig out how to post pic.
http://www.rctech.net/forum/attachme...12-forum-8.jpg

New 1/12 driver in need of some advice. My car wants to hook left when coming out of slow corners. Its not hard enough to not be able to correct but makes the car difficult to drive. What should I be looking at to fix this problem? Its a VBC lightning V2 running 17.5
Thanks

What would be a good 1/12 car to start with for a beginner? Parts availability is not an issue as I live in the boonies and have to order my stuff anyway.

Those are front end upper arm eyelets with side link pivot balls.

I have a few crc gen xl cars and they are great. Basically anything with the open rear pod for brushless is nice. I have an old crc carpet knife that still works great too, just more difficult to get the brushless motor/wires in it than with the bit newer ones. Here's a link to a nice car on the forums here, almost rtr for a good price.

http://www.rctech.net/forum/r-c-item...c-xti-arr.html

The upper eyelets won't fit the 5mm side link balls. These are the ballcups that were used on the R5 shaft through dampers (center & side), only made shorter.

For a sub $100 ESC to get that is 1S specific with BEC Booster circuit which one do you think is to get? Any experiences with either of them?

SMC 1S RF-120

Skyrc Toro 1S 120


I would like to get a Reedy Blackbox 410R but need to keep the costs of getting into 1/12 reasonable. Thanks,

I've been really pleased with my Turnigy 1c speedo from Hobbyking. And it was super inexpenive too.

I just got the smc and it's pretty nice for the low price. All aluminum case, fits in the car nicely. I haven't had it very long but happy so far.