Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
|
|||
Will
Which Ti rod are you using ?
Which Ti rod are you using ?
Tech Master
iTrader: (8)
The b5 rear arms will give me more forward bite right ? Will they take away from my rotation ? the buggy is turning good but has horrible forward bite
Tech Master
iTrader: (21)
Tech Master
iTrader: (8)
Should I buy brass arm mounts C and D or alumunim? Im running Mod. when would I need one or other. Brass heavier i know right. So i can use it as a tuning option?
Tech Champion
iTrader: (22)
Depends on if you feel you need the extra weight. If you run on high bite, probably not. If you run on lower bite, probably a good idea.
I'm of the mindset now that if need to add 40 grams to the rear of the car, I'll just run rear motor. Call me crazy LOL
I'm of the mindset now that if need to add 40 grams to the rear of the car, I'll just run rear motor. Call me crazy LOL
Using 2.7 oz extra weight under the short pack,not just for traction.
Also for a lower CG which helps smooth out the car on higher traction conditions.
Also for a lower CG which helps smooth out the car on higher traction conditions.
Tech Master
iTrader: (8)
i run square pack in mine it feels better than shorty probably because of low to medium traction. i put some weight on back of shock tower down low above rear suspension holder seemed to make the car not to want to turn kinda pushy
Tech Elite
iTrader: (47)
im switching my car back to rm from mm, whats everyone prefer for a med to higher bite tracks…gull wing fronts or straight arms?
Tech Adept
Did someone post a graphical comparison of the 2 front towers, i.e. showing the differences in shock mount positions...? I remember seeing one, just can't find it now...
Tech Addict
iTrader: (13)
I have 1 3/4" lunsfords on mine. All the stock cups were fine. Broke one turnbuckle, installed replacement with new rod ends and they bind.
Luckily a quick turn with a 5.7mm ball cup reamer and good to go.
Last time I will chime in about the rod ends.
Luckily a quick turn with a 5.7mm ball cup reamer and good to go.
Last time I will chime in about the rod ends.
shocks are at the same angle as using rear motor tower middle hole.
Difference is the shocks are lower a couple mm with mid tower & inside tower hole.
Lower makes for lower CG on front .
Makes for smoother steering.
Sorry never seen that graph.
I just thought maybe you were interested.
Last edited by Wild Cherry; 08-17-2014 at 05:53 PM.
Tech Regular
iTrader: (2)
R/C Tech Elite Member
iTrader: (38)
Are these the correct turnbuckles for the B5 ?
http://www.amain.com/JConcepts-B4-Ge...-Set-6/p254966
http://www.amain.com/JConcepts-B4-Ge...-Set-6/p254966
Tech Master
iTrader: (1)