Awesome! I am quite jealous. What electronics are you going to run?

R10 pro with 8.5

No setups on Kyosho site yet

And the build begins.

Just want to give a shout out to HRP for getting my kit to the LHS so quickly.

I may be doing something wrong, but the cvd's hit the top of the out drives on trany before the shock bottoms out. Anyone else or what did I do wrong?

Got my kit today from LA Parts House. I believe they got a few in yesterday if anyone is looking.

After reading this I checked mine when I got to this step and it looks like mine would bottom out as well so I put both 1mm spacers on the outside of the rear hub. seems to work ok now.

Two tips when building:
Install the front shock tower to the bulkhead before installing the bulkhead.

The plastic used for he bumpers and body mounts is very soft, don't over tighten the screws.

How are you guys setting them up as far as lipos? I run all shorty in my rb6 and rt6. Anyone running full stick in rm or perhaps WTS orion packs?

I am going to start with a shorty placed all the way back then make adjustments as needed. Running 17.5 in mid motor.

what gearing are you planning on running with 17.5? stock spur is 80, are you planning on using a different spur?

Where you race ?????

I'll be running shorty saddle pack and stick with r10 esc and 6.5t vst2 hitec 7940 let's see how she does so excited

Sounds like an aweful lot of electronics swapping and chassis protector removal/reinstall. Let us know which one you like the best!

I had my scr geared at 28/72, I will start there on this truck.

I finely got the shocks built and I have a problem. I built mine with the MIP puck system and UMW705 (D-in) and UMW707 (C-in) and even with both 1mm spacers on the outside of the hub the dogbone still bottoms out in the outdrive. looks like I need to limmit the up travel or widen the track with.

Whats the different from the SCR and the new SC6 ?
sorry...new to 2wd !!